2007 10hp Johnson Heating up

harv50

Recruit
Thread starter
Joined
Apr 25, 2016
Messages
1
I have a 2007 10hp, 4cycle Johnson that I haven't used for about 3 years now so I decided to put it in a barrel and check it out. Had to use some spray

Seafoam to get it started (it was ran out of gas when I quit using it but still gummed up I guess). After I got it started I let it idle for a 1/2 hour (it was

showing a good stream of water). So I added another 1/3 of a can of Seafoam to the 2 gal of fresh gas and cranked it up to about 1/3 - 1/2 throttle and

was going to let it run for another 1/2 hr.

BUT after about a minute I felt the water and it was getting really HOT. I idled it back down and it immediately

cooled back down, (did this 3 times in a row). So I pulled the thermostat and it starts to open at 140 and is fully open at 150. When run at 1/2 throttle it

is throwing about twice the stream of water as it does at idle.

Only thing I can think of is the impeller (but it throws a lot of water, maybe to much???).

Any help would be greatly appreciated..
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
Maybe not enuff water in the barrel.--------Maybe too many exhaust bubbles in the water.------Best to do a test out on the boat.
 
Top