I have a 2007 10hp, 4cycle Johnson that I haven't used for about 3 years now so I decided to put it in a barrel and check it out. Had to use some spray
Seafoam to get it started (it was ran out of gas when I quit using it but still gummed up I guess). After I got it started I let it idle for a 1/2 hour (it was
showing a good stream of water). So I added another 1/3 of a can of Seafoam to the 2 gal of fresh gas and cranked it up to about 1/3 - 1/2 throttle and
was going to let it run for another 1/2 hr.
BUT after about a minute I felt the water and it was getting really HOT. I idled it back down and it immediately
cooled back down, (did this 3 times in a row). So I pulled the thermostat and it starts to open at 140 and is fully open at 150. When run at 1/2 throttle it
is throwing about twice the stream of water as it does at idle.
Only thing I can think of is the impeller (but it throws a lot of water, maybe to much???).
Any help would be greatly appreciated..
Seafoam to get it started (it was ran out of gas when I quit using it but still gummed up I guess). After I got it started I let it idle for a 1/2 hour (it was
showing a good stream of water). So I added another 1/3 of a can of Seafoam to the 2 gal of fresh gas and cranked it up to about 1/3 - 1/2 throttle and
was going to let it run for another 1/2 hr.
BUT after about a minute I felt the water and it was getting really HOT. I idled it back down and it immediately
cooled back down, (did this 3 times in a row). So I pulled the thermostat and it starts to open at 140 and is fully open at 150. When run at 1/2 throttle it
is throwing about twice the stream of water as it does at idle.
Only thing I can think of is the impeller (but it throws a lot of water, maybe to much???).
Any help would be greatly appreciated..