So I have read a few post over here and I think I'm on the right path but I would like to confirm before I buy a new PDP. The issue started when my starter didn't engage the flywheel so we brought the gear up and started the engine. We turned it off and started again and no issue for the next 2 operation. Then the starter failed because the gear wouldn't spin but heard it spin inside so I bought a new one. It lasted about 4-6 times and when I pulled out of the marina, my check engine went off but didn't notice any anormalities and it was pissing water. Pulled to the dock and turned it off, waited 5 minutes and tried again but the starter didn't have enough juice to go more than a quarter turn. Looked at the solenoid and it was really green so I went to the local shop and the mecanic bypassed it with a screw driver and the starter worked so I bought a new one. Still won't crank more than a quarter turn and my fuel pump is not priming.
As per a previous post, I cheched the yellow/blue wire at the solenoid and I have about 4 volts. I also measure the voltage at the fuel pump and have less than 4 volts. I checked the gounds between motor and battery, from the EMM, under the solenoid and it looks good. I also verified the voltage between the red and black at the PCP and I have 12 volts. I then checked the voltage on the red/black fusible link between the PCP and EMM and I got 4 volts.
My questions is: should I get 12 volts out of it and is it feeding the EMM or is it the opposite?
Any help would be greatly appreciated.
As per a previous post, I cheched the yellow/blue wire at the solenoid and I have about 4 volts. I also measure the voltage at the fuel pump and have less than 4 volts. I checked the gounds between motor and battery, from the EMM, under the solenoid and it looks good. I also verified the voltage between the red and black at the PCP and I have 12 volts. I then checked the voltage on the red/black fusible link between the PCP and EMM and I got 4 volts.
My questions is: should I get 12 volts out of it and is it feeding the EMM or is it the opposite?
Any help would be greatly appreciated.