First post here, thank you all in advance. Promise to give back as I complete this project, basically my first rebuild on a modern outboard.
Long story short ended up with a '99 50HP 4 stroke (twin to Suzuki DF50), had some water in the oil so made an impulse buy figuring it would be an fun project for my son and I. Once I got it on a stand found and did a compression test it came back 180/178/90. Even more telling than the compression test, water was actually being ejected out the #3 cylinder on compression.
Just got around to pulling the head off last night and saw a ton of salt and scale caked on the head (and some in the cooling jackets as well). Was able to remove most of it, but on the cylinder head it appears that the salt has eaten away part of the head. I was just removing the salt/scale with a small screwdriver and the aluminum was pretty brittle as well and was flaking off on the surface.
Is this something I can just take to a machine shop (have them grind, build up and reduce), or should I be looking at sourcing a replacement casting? The motor only has 150 hours on it, but was all in the salt and probably got its first flush a week ago..
Appreciate any thoughts here, see attached (head before and after scale removed).
Thank you!

Long story short ended up with a '99 50HP 4 stroke (twin to Suzuki DF50), had some water in the oil so made an impulse buy figuring it would be an fun project for my son and I. Once I got it on a stand found and did a compression test it came back 180/178/90. Even more telling than the compression test, water was actually being ejected out the #3 cylinder on compression.
Just got around to pulling the head off last night and saw a ton of salt and scale caked on the head (and some in the cooling jackets as well). Was able to remove most of it, but on the cylinder head it appears that the salt has eaten away part of the head. I was just removing the salt/scale with a small screwdriver and the aluminum was pretty brittle as well and was flaking off on the surface.
Is this something I can just take to a machine shop (have them grind, build up and reduce), or should I be looking at sourcing a replacement casting? The motor only has 150 hours on it, but was all in the salt and probably got its first flush a week ago..
Appreciate any thoughts here, see attached (head before and after scale removed).
Thank you!
