G
Guest
Guest
I bought a new VRO Tank (w/ System Check) assembly for my 98 Ocean Pro 200.
I followed the instructions and everything went in fine, but there is a 2 wire and 2 -prong male Deutsch connector (black wire and black/tan wire) coming from the top of the VRO tank.
There's no female Deustch recepticle to hook it up on the motor, or my binnicle control (every Deustch connector is spoken for)
I pulled the panel on the port side of the motor where the control harness plugs in, and I have (2) 3 prong triangular Deutsch connectors and (2) 6 prong Deutsch connectors. but there is nothing on the power head to accommodate this 2 prong male connector from the VRO tank. (There is also a 2 wire connector below this panel (non Deutsch) that is described in the OMC tech Manual as a VRO "connection".
The directions for the tank say nothing about where this connects to, and even my 1998 OMC shop manual doesn't say where this 2 prong wire from the tank hooks up. The only thing I can can think of is if this tank is for a pre-96 motor.
Otherwise, does my origina (1998) harness on the motor sense the level in the VRO tank and not the separate lead wire off the tank.?
Any help is apprciated. Thanks!
I followed the instructions and everything went in fine, but there is a 2 wire and 2 -prong male Deutsch connector (black wire and black/tan wire) coming from the top of the VRO tank.
There's no female Deustch recepticle to hook it up on the motor, or my binnicle control (every Deustch connector is spoken for)
I pulled the panel on the port side of the motor where the control harness plugs in, and I have (2) 3 prong triangular Deutsch connectors and (2) 6 prong Deutsch connectors. but there is nothing on the power head to accommodate this 2 prong male connector from the VRO tank. (There is also a 2 wire connector below this panel (non Deutsch) that is described in the OMC tech Manual as a VRO "connection".
The directions for the tank say nothing about where this connects to, and even my 1998 OMC shop manual doesn't say where this 2 prong wire from the tank hooks up. The only thing I can can think of is if this tank is for a pre-96 motor.
Otherwise, does my origina (1998) harness on the motor sense the level in the VRO tank and not the separate lead wire off the tank.?
Any help is apprciated. Thanks!