1998 Johnson 150 ocean pro RPM problem

Rmaxx 13

Recruit
Thread starter
Joined
Aug 8, 2016
Messages
1
Greeting fellow boaters
I'm new to the forum, thanks for having me.
I have a1998 OMC Hydra sport 1900 (19 foot center console) I have a 1998 Johnson Ocean pro 150 "Looper" carbed motor.
Problem: Start the engine at the dock, let it idle for about 5 minutes, getting everything ready. Back out, idle to the end of the no wake zone, about 200 yards. Start getting into the throttle, get the boat on plane, the RPM's will go to 5400. BUT 15 minutes into the run, it drops back to 4450 and stays there. when I get to a fishing spot, I shut down, fish for a couple of hours, start the motor and it still will not go over 4450. BUT if I let the boat sit over night, it'll do the same thing. Its done this for the five years I've owned it. I've replaced ALL fuel lines from the tank to the motor, new plugs wires, coils, pulled and cleaned all connectors, checked all the throttle rigging, timing rigging. so I'm stumped any help would be appreciated.
Brian
 

bob johnson

Rear Admiral
Joined
Feb 25, 2009
Messages
4,306
I don't really KNOW whats causing your issue, but I would look at two places... I look at the tach itself... probably unlikely, but Id install another tach just to verify. then I also look at the power pack...it might be a warming issue that once the pack gets to a certain temp, something happens inside.....again just a guess.....

good luck


bob
 

reiddo1

Petty Officer 2nd Class
Joined
Jan 17, 2012
Messages
166
I have a 2000 Johnson Oceanpro that could not rev past 4800 Rpm either hot or cold. Clamped the fuel bulb fittings with gear hose clamps and now get 5200 rpm. Might be worth a try since cost is insignificant.
 

bob johnson

Rear Admiral
Joined
Feb 25, 2009
Messages
4,306
I have a 2000 Johnson Oceanpro that could not rev past 4800 Rpm either hot or cold. Clamped the fuel bulb fittings with gear hose clamps and now get 5200 rpm. Might be worth a try since cost is insignificant.

thinking about that...it seems you are saying you had an air leak.....I would think that would give you more lean a mixture, and more rpm!!!

id try it no matter what, because you don't want leaks period!!

bob
 

reiddo1

Petty Officer 2nd Class
Joined
Jan 17, 2012
Messages
166
I expect I would have been running leaner; as to whether less fuel to air makes the engine speed increase, that is one I cannot understand. All I know is that immediately after replacing the compression clamps on the bulb primer with gear hose clamps and no other changes, the rpm went to 5200 at wot.
 
Top