Greeting fellow boaters
I'm new to the forum, thanks for having me.
I have a1998 OMC Hydra sport 1900 (19 foot center console) I have a 1998 Johnson Ocean pro 150 "Looper" carbed motor.
Problem: Start the engine at the dock, let it idle for about 5 minutes, getting everything ready. Back out, idle to the end of the no wake zone, about 200 yards. Start getting into the throttle, get the boat on plane, the RPM's will go to 5400. BUT 15 minutes into the run, it drops back to 4450 and stays there. when I get to a fishing spot, I shut down, fish for a couple of hours, start the motor and it still will not go over 4450. BUT if I let the boat sit over night, it'll do the same thing. Its done this for the five years I've owned it. I've replaced ALL fuel lines from the tank to the motor, new plugs wires, coils, pulled and cleaned all connectors, checked all the throttle rigging, timing rigging. so I'm stumped any help would be appreciated.
Brian
I'm new to the forum, thanks for having me.
I have a1998 OMC Hydra sport 1900 (19 foot center console) I have a 1998 Johnson Ocean pro 150 "Looper" carbed motor.
Problem: Start the engine at the dock, let it idle for about 5 minutes, getting everything ready. Back out, idle to the end of the no wake zone, about 200 yards. Start getting into the throttle, get the boat on plane, the RPM's will go to 5400. BUT 15 minutes into the run, it drops back to 4450 and stays there. when I get to a fishing spot, I shut down, fish for a couple of hours, start the motor and it still will not go over 4450. BUT if I let the boat sit over night, it'll do the same thing. Its done this for the five years I've owned it. I've replaced ALL fuel lines from the tank to the motor, new plugs wires, coils, pulled and cleaned all connectors, checked all the throttle rigging, timing rigging. so I'm stumped any help would be appreciated.
Brian