Mriplaybass
Recruit
Thread starter- Joined
- Feb 27, 2018
- Messages
- 5
A few years ago, I had a rod blow a hole in the crankcase. Now that I'm retired, it's time to fix it! The problem that I am having is getting the power head separated from the lower housing. I have disconnected everything that needs to come off. I have removed the lower unit. I have removed 4 bolts and 1 nut on each side of the power head, and 1 nut at the rear above the exhaust. When I try to lift the power head off, the entire boat and trailer lifts up. I tried putting the front 2 nuts almost all the way on, then with tension on the lift, pried up on the nuts. Nothing! The power head won't budge. I tried gently heating with a propane torch around the gasket under the power head, but this did nothing. Right now, I am trying to use a razor saw, and split the gasket that way. Very slow going, and I don't think I can reach all the way around.
Does anyone have any ideas on how to break the power head loose? According to the shop manual, I have everything loose, or am I missing something?
Does anyone have any ideas on how to break the power head loose? According to the shop manual, I have everything loose, or am I missing something?