1989 evinrude 200hp trouble starting.

TNtarpon

Recruit
Thread starter
Joined
May 25, 2016
Messages
3
Ok so the motor has always been a little hard to start but Always started. I would usually have to sit and crank it a few times to get it to fire, before eventually it would start, but it would always fire. Once the motor was fully started and warmed up It would start first turn of the key for the rest of the day.

Well its been about a month ago I was running the boat and suddenly it slowly lost power. Took it to the shop, VRO pump went out. They also told me they had to put new spark plugs in just to get it to fire. I asked what fouled them and was told it probably happened when I lost power. Took the boat out following day started and ran fine. Took it out that weekend, also ran fine. Boat sat for about 2 1/2 weeks before I took her out again, I absolutely could not get the boat to start. Wouldn't even fire. I tried the following day to get it to start and never could get it to fire. Took it back to the shop and told them what was going on, they said It might be a power pack going bad. They called me that afternoon and said the boat cranked right up no issues... So I went and picked the boat up the following day at lunch, talked to one of the guys and he said they cranked if for about 5 seconds and it started. That afternoon after work I took it home and sure enough couldn't even get it to fire. Very confused. I didn't have the right size wrench to pull the plugs but I will this afternoon. Im going to see if the plugs are fouled, I have a feeling they are.

Im pretty frustrated because it always acts up at home and not the shop. Anyone have any suggestions on what to check first or what the issue might be?
 

interalian

Commander
Joined
Jul 23, 2009
Messages
2,105
Maybe your starting procedure isn't right. Do you:

1) Pump primer ball until firm
2) Lift fast idle lever to top
3) Turn key to 'crank' while pushing key in to prime
4) Once it fires, adjust idle and bump the key in to add some more fuel while it's warming
5) Lower fast idle lever as motor warms

Or?
 

TNtarpon

Recruit
Thread starter
Joined
May 25, 2016
Messages
3
Just got a chance to pull the plugs. The top 4 where a little dirty, not too bad. The bottom 2 where soaking wet. Cleaned all the spark plugs and put them back in. tried cranking her twice, no fire. Pulled the plugs and the bottom two where again completely soaked. Called the maintenance shop, told them what was going on. He said it sounded like something electrical, maybe a switch box going bad or another electrical component in the ignition system.

Does this sound right?

Also at one point the boat started up with just a simple turn of the key, instantly. Right after we got it the kill switch was accidentally pulled and killed the boat. When it killed the boat it blew the main fuse. Replaced the fuse and it still didn't give power, took to shop and they found a bad wire leading to the fuse. fixed that wire and it fixed the problem, but ever since then it has been a pain to get started. having to crank it over for a while and everytime it would fire it would send the starter bendix down and I would have to turn the key back and then re turn it. But now it wont even do that, it just turn over and over and over never firing
 
Last edited:

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
Are you pushing the key IN while cranking it over as suggested earlier.-------You failed to address this ?
 

TNtarpon

Recruit
Thread starter
Joined
May 25, 2016
Messages
3
yes, pushing key in while cranking. I push in key, hear the solenoid "click" then crank. The solenoid clicks basically instantly when pressing in the key
 

racso

Seaman
Joined
Jun 29, 2014
Messages
56
maybe humidity in the gas try adding some sea foam liquid I had the same problem with my motor.. and I added that liquid and it worked fine.. but the carbs where very dirty so I had to rebuild them completely and no problems now .. good luck try that and see
 
Top