1988 90hp johnson engine knock

usmarshal1018

Recruit
Thread starter
Joined
Nov 4, 2015
Messages
2
starts and idles fine after warm up. get into it a little and hear a knocking sound. I know that is not a lot of information, but any ideas would be appreciated.
 

flyingscott

Fleet Admiral
Joined
Apr 8, 2014
Messages
8,348
Hello take all your spark plugs out and start at the #1 cyl. Turn the flywheel until the piston just starts its down stroke. Now take a wooden dowel or similiar not metal and put it in the hole and push on the piston. If you here a clunk thats the piston that's knocking. Be careful when you start the piston on the down stroke don't go down to far where the piston ring is lined up in the port. Also grab your flywheel and see if you have a lot of movement in it that could indicate a crank bearing problem.
 
Last edited:

emdsapmgr

Supreme Mariner
Joined
Dec 9, 2005
Messages
11,551
When a crossflow gets a lot of hours on it, the pistons wear in the bores. When it gets really worn, you can hear pistons slap when the engine is running. This is normal, caused by the piston skirts slapping the cylinder walls as the engine rotates. More evident at lower rpms. Undistingushable at WOT. Though it may sound bad, it is not a sign that the powerhead will fail in the near future. If you were to overbore it and put in new pistons-that should resolve that problem.
 

usmarshal1018

Recruit
Thread starter
Joined
Nov 4, 2015
Messages
2
Thank you for the replies. I have never worked on an outboard motor before. While it is in great shape overall, I am trying to decide if i should sink money into it, if it is something other than a tune up. Again, thank you.
 
Top