1986 Evinrude 40 Hp E40ELCDE Carb Problems?

dkosiewicz

Seaman Apprentice
Thread starter
Joined
Jun 28, 2017
Messages
39
I just hoguht of something could my timing be off on my motor? And if so what degree should it be set at for a 1986 E40ELCDE Evinrude? And how do you set it? I have youtubed it but still a little lost. I think picture #2 is where I would adjust my timing? And picture #3 is where I adjust my idle speed.
20170702_102345.jpg 20170702_102405.jpg 20170702_102352.jpg
 

kaivorth

Seaman
Joined
Jun 26, 2018
Messages
51
Did you ever figure this out? Same exact issue. Starts, won't idle and then dies. I think in my case the compression is a little low so I'm hoping a little seafoam in the spark plugs will free anything that stuck.
 

Rustywrench

Petty Officer 1st Class
Joined
May 10, 2018
Messages
209
Showing those last pictures I believe someone has gotten confused & agjusted your timing screw thinking it was your idle screw? Never should be advanced that far. Motor should be around 19* at WOT. It also looks like the idle screw has been confused with the timing screw. It is backed off probably too far. Good compression numbers are critical on this motor, but if in doubt pull the head & look at cylinder condition?
The 4 wire VRO requires an addional harness #174710, but just gives you the purple wire with the pin & connector for the pump. The wire has a ring terminal & instruction sheet of how to convert pump. The purple wire provides consistent power for the warning horn. You may not be able to put the parts from your new pump into your old pump? Improve,nets were made in diaphragm designs & o-ring seals.
 
Top