Travis2329
Cadet
Thread starter- Joined
- Jun 1, 2017
- Messages
- 15
Ok so here is what i have, it is a 1986 E90mlcdc outboard with a 1983 e90mlcte powerhead. Was put together prior to me owning it and i would have never noticed if it wasnt for the silver freeze plug on the block.
I have done a compression test and everything came back good. All ignition components are new except the timer base (new stator, power packs, coils and plugs) . New fuel line from tank to motor as well as a new pickup tube and anti-siphon valve. Carbs were rebuilt last month. Rebuilt fuel pump. New prop (same pitch as last one) and new lower unit oil. I have hose clamps on all fuel line connections. The vro pump has been removed and i premix fuel 50:1.
Heres my issue, when i take the boat out it runs great from 0-4000 rpm. If it gets higher than 4000 rpm it will run good for about 20 seconds and then bog down, but wont die just surges up and down in rpm but if i back off to 4000 rpm it will catch itself and run good all day long but only at 4000 or lower....
Im thinking its a fuel related issue since everything else is new but i cant even think of where... maybe carb float needle is sticking and starving for gas?
Also i ran it without the cowling to see if exhaust fumes were collecting under the cowl and starving the engine of air but i had the same issue...
Any help is appreciated... im so lost...
I have done a compression test and everything came back good. All ignition components are new except the timer base (new stator, power packs, coils and plugs) . New fuel line from tank to motor as well as a new pickup tube and anti-siphon valve. Carbs were rebuilt last month. Rebuilt fuel pump. New prop (same pitch as last one) and new lower unit oil. I have hose clamps on all fuel line connections. The vro pump has been removed and i premix fuel 50:1.
Heres my issue, when i take the boat out it runs great from 0-4000 rpm. If it gets higher than 4000 rpm it will run good for about 20 seconds and then bog down, but wont die just surges up and down in rpm but if i back off to 4000 rpm it will catch itself and run good all day long but only at 4000 or lower....
Im thinking its a fuel related issue since everything else is new but i cant even think of where... maybe carb float needle is sticking and starving for gas?
Also i ran it without the cowling to see if exhaust fumes were collecting under the cowl and starving the engine of air but i had the same issue...
Any help is appreciated... im so lost...