1985 Johnson 25hp running on one cylinder

Xtyfighterx

Cadet
Thread starter
Joined
Oct 2, 2016
Messages
8
Hello bought my first boat two days ago. Put new mixed gas in got it running took it to the lake and it surges on high idle. I messed with the low idle pin nothing would work. Took it back home and did the following

Clean the carb checked all gaskets used pressurized air to clean the ports
Compression check 100 on both cylinders
New plugs
Check my spark arcing at 7/16
Used a meter checking my coil packs
Swapped plug wires
Check my fuel pump diaphragm
New main fuel line and fuel tank
Seafoam in the fuel.
Also put some fuel in the top cylinder that's dead and removed the bottom plug wire to the bottom cylinder it started and ran for a few mins


It Starts first pull and idles great runs ok until high idle. Top cylinder is dead. Runs with out the plug wire on.

Any help please
 
Last edited:

kbait

Commander
Joined
Nov 13, 2007
Messages
2,488
Did you inspect the reeds when you had carb off? Perhaps a leaf is broken or stuck open on the reed set that feeds that cylinder.

Good luck!
 

Xtyfighterx

Cadet
Thread starter
Joined
Oct 2, 2016
Messages
8
Did you inspect the reeds when you had carb off? Perhaps a leaf is broken or stuck open on the reed set that feeds that cylinder.


Good luck!

No I didn't. I originally thought the carb cleaning would fix it then I later found out it was running on one cylinder
 

Xtyfighterx

Cadet
Thread starter
Joined
Oct 2, 2016
Messages
8
if it were the reeds it would run rich and bad at idle right?mine runs good at idle and low mid throttle. Full throttle it surges
 

Xtyfighterx

Cadet
Thread starter
Joined
Oct 2, 2016
Messages
8
Primer wasn't closed all the way flooding the top cylinder apparently and the spark plugs weren't champion plugs. Mechanic says it's good to go I'm gonna try it tomorrow
 
Top