1982 50hp Evinrude running issue

chargereiger6907

Recruit
Thread starter
Joined
Oct 16, 2017
Messages
2
Hey guys, new to the forum here. I bought this 1982 50hp evinrude over the summer and have been having problems with it running in the water. Did a compression check on both cylinders and they are 130psi. Rebuilt both carbs, all new fuel system from the fuel pump to the gas tank, new coils and powerpack. With the motor running on ears it runs great but once the motor is in the water it will only run with the cover off and runs very sluggish. Is there some type of air-fuel adjustment screw on the carbs??? I'm lost at this point. Thanks
 

juno pierrat

Petty Officer 1st Class
Joined
Dec 14, 2013
Messages
355
when rebuilding carbs, how detailed did you get, core plug removed? rebuild kits? fuel orifices remover or wired clean?
 

chargereiger6907

Recruit
Thread starter
Joined
Oct 16, 2017
Messages
2
I bought a rebuild kit and replaced everything it came with. I took apart both carbs and cleaned it with a carb cleaner spray and basically tried to spray it in every spot possible. I took the jets out and cleaned them(they were clogged original) as well. Out of the water with no engine cover on it, it runs fine and revs high. Once i put the engine cover on it, it immediately shuts off.
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
Check the sparkplug wires for damage !----And have you considered looking at the flywheel key ( timing control ) is what it looks after.
 

juno pierrat

Petty Officer 1st Class
Joined
Dec 14, 2013
Messages
355
Your carbs are fixed jets and have no adjustments besides link-and-sync. Check for restrictions in cowling air intake or exhaust leak filling cowling with exhaust.
 
Top