mackinawmarauder
Recruit
Thread starter- Joined
- May 18, 2017
- Messages
- 2
Evening,
I've got a 79 Johnson 100 Javelin (100TLR79S) that gave me starting issues out on the lake last year. Typical symptoms - starts fine on muffs but once in the water it takes a certain amount of finesse to get it to start. Originally I thought it was a fuel issue and got all new lines and rebuilt the carbs. Yesterday I decided to do a compression check, knowing in the back of my head that I wouldn't like the outcome.
Compression check was done with a fully charged batter, motor was cold and I got 49-50 in all four cylinders.
So now I'm having a dilemma. My father thinks I should just tune it and run with it till it dies since once started and warmed up in the water it has no issues staying running or moving around on the lake, then the day it does die upgrade to a newer engine. I on the other hand think a top-end rebuild would get me some more life out of this engine since everything else works well on it.
What would you do? Anyone in this situation had good luck with rebuilding the top-end?
I did pull the heads and did not observe any gouging or scoring of the cylinder walls.
If I did land up re-building the top end would a simple hone and new rings/pistons do the trick, if tolerances are fine?
I've got a 79 Johnson 100 Javelin (100TLR79S) that gave me starting issues out on the lake last year. Typical symptoms - starts fine on muffs but once in the water it takes a certain amount of finesse to get it to start. Originally I thought it was a fuel issue and got all new lines and rebuilt the carbs. Yesterday I decided to do a compression check, knowing in the back of my head that I wouldn't like the outcome.
Compression check was done with a fully charged batter, motor was cold and I got 49-50 in all four cylinders.
So now I'm having a dilemma. My father thinks I should just tune it and run with it till it dies since once started and warmed up in the water it has no issues staying running or moving around on the lake, then the day it does die upgrade to a newer engine. I on the other hand think a top-end rebuild would get me some more life out of this engine since everything else works well on it.
What would you do? Anyone in this situation had good luck with rebuilding the top-end?
I did pull the heads and did not observe any gouging or scoring of the cylinder walls.
If I did land up re-building the top end would a simple hone and new rings/pistons do the trick, if tolerances are fine?