1978 Johnson 25 skeg compatable with 1976 skeg?

gaffemaster

Cadet
Thread starter
Joined
Jul 6, 2015
Messages
9
Long story short I apparently had water in my lower unit on a 1978 Johnson 25hp short shaft (25R78C) and it froze and cracked pretty good. I bought a skeg from a 1976 and was told by several people that it will work just fine but one guy I spoke with says 1978 was a unique year and I should not use the '76 skeg on the '78 even though it fits. Took it to my boat guy and he took a few measurements and said he would have no problem putting the different skeg on but this other gentleman I spoke with said it would basically be a short term repair. Part numbers on the inside are the same but there looks to be a slight difference in machining in a couple spots. Should I bolt up the '76 skeg and run it with my fingers crossed or should I search for a true 1978 skeg? Or should I look at getting it welded or JB weld it up? I'd like to make the proper repair and not have to worry about it. Any help is greatly appreciated. Thank you.
 

Faztbullet

Supreme Mariner
Joined
Mar 2, 2008
Messages
15,938
You should not mix and match as lower housing (skeg as you call it) is it is machined to match your upper housing..that why they are not sold separate.Will it work maybe but I wont try it...
 

F_R

Honorary Supreme Mariner
Joined
Jul 7, 2006
Messages
28,226
You are not supposed to mix them because the two parts are bolted together, then the inside is bored. Therefor, no two are exactly alike. OK, having said that, reality says that people have mixed them and gotten away with it. Part luck and part, well..luck.
 

kbait

Commander
Joined
Nov 13, 2007
Messages
2,488
Bolt on replacement skeg and test for binding. Spin driveshaft by hand, testing FNR..if it's all smooth you should be good. I've replaced several w/o issue. If there's any binding, try a different replacement, or find a used gearcase housing.
Good luck!
 

gaffemaster

Cadet
Thread starter
Joined
Jul 6, 2015
Messages
9
Thanks for all the responses. Greatly appreciated. I bolted everything up and the gears turn freely so I'm going to give it a shot. Talked to a couple local mechanics and they both said I should be fine. I hope luck is on my side. Will report back with results. Thanks again guys.
 
Top