1977 Johnson 140 Electrical Problems

ewiens40

Cadet
Thread starter
Joined
Jun 7, 2003
Messages
6
I have a 1977, 140 Johnson Outboard. The motor is only firing on 2 cylinders, both on one side. I checked both sensor coils with a miltimeter. They both measure within the acceptable ranges in the manual. When I switch the wires from the sensor coil to the power pack, the spark plugs spark on the other side so I assume my power pack is OK. I removed the key switch lead and turned the motor over, the two plugs continue to spark. The manual lead me to believe that this indicated it was either the switch lead or the switch. The lead is fine and I removed the switch and emergency stop button and it still only sparks on two cylinders. What do you think the problem is?
 

Hooty

Rear Admiral
Joined
Oct 2, 2001
Messages
4,496
Re: 1977 Johnson 140 Electrical Problems

Have a look at your charging coils. I think one of them is bad.<br /><br />c/6Hooty
 

ewiens40

Cadet
Thread starter
Joined
Jun 7, 2003
Messages
6
Re: 1977 Johnson 140 Electrical Problems

The charge coil leads register 608 ohms when connected together. This is within the acceptable range. Both charge coil leads deliver 49V when the engine is cranked. The Sensor wires each deliver 260 - 265 V when the engine is cranked.The power pack delivers 0.07 V @ 20 to coil lead 3, 0.13 V @ 20 to lead 5, 0.75 - 1.00 V @ 20 to lead 10 and 1.15 - 1.70 V @ 20 to lead 11 on my multimeter. The strange part is that when I switch the coil sensor wires around the cylinders on the other side fire. I think the charge coils are OK and I also believe the sensor coils are OK and that the power pack is not working. With this conclusion I can't explain why the sparks change cylinders when I reverse the sensor coil leads. Is this a reasonable assumption? If so, is there another test I can do to confirm it is the power pack?
 
Top