1977 evinrude 115 reverse problem

mobley

Cadet
Thread starter
Joined
Aug 27, 2009
Messages
9
I have a 115 hp 1977 evinrude that doesn't want to go in to reverse. It will go but it pops out. The guy I got it from changed the impeller in it and he said it hadn't worked right sense he did that. What could be wrong and what can I do to fix it.
Thanks
Brian
 

emdsapmgr

Supreme Mariner
Joined
Dec 9, 2005
Messages
11,551
Re: 1977 evinrude 115 reverse problem

Proper shifting of the lower unit depends on the lower unit shift rod being set at the correct height. Always possible that the shift rod was screwed in or out during the water pump install. That will change the adjustment and make for odd shifting. I'd remove the shift cable at the engine end and see if you can get the engine to shift properly by hand. If it will shift normally by hand, you can probably reset the position of the cable by turning the thumb wheel on the engine end of the cable. If you can't you will probably have to remove the lower unit again and reset the shift rod height. The "height" is measured from the top of the lower unit casting, to the centerline of the shift rod eye, set in neutral. For a 20" standard lower unit, the height meassurement is: 21.411" +- 0.36"
 

mobley

Cadet
Thread starter
Joined
Aug 27, 2009
Messages
9
Re: 1977 evinrude 115 reverse problem

I have tried adjusting the cable and it didn't make it any better. How hard is it to remove it and adjust the shift rod. I am good at working on cars and trucks. Never worked on a boat motor before don't want to make the problem any worse.
 

boobie

Supreme Mariner
Joined
Nov 5, 2009
Messages
20,826
Re: 1977 evinrude 115 reverse problem

That mtr doesn't have a shift rod adjustment spec. You screw the the coupler in on the top of the shift rod in until it bottoms out and then back it out maybe 1/2 turn to align with the linkage under the carbs on the mtr. Don't forget the little plastic bushing part # 318590 that goes into the connector.
 
Top