I was on the POR15 website, they have really expanded their product line. They have many colors, UV top coat paint, bedliner, clear metal protectant etc. Ive always been happy with Rusto, but never used the hardner, might go that route. I've seen the stiffner mod, I'm not sold on it, but it wouldn't hurt anything as long as it's installed right. Ill have to dive deep into the debate, what's the best thread for that? Two things on my mind that Id appreciate feedback on: im about to do the transom, but haven't choose an engine setup yet. I wasn't planning on locking in a type or set up untill next year, but with the bolt holes in the transom, I may need to make that choice. Short of welding up all the holes in the skin, or attaching a transom plate, is this a choice i have to make now? I have a functional CMC tiltntrim, so I can hang anything off the back, but what if i spring for a dual motor set up? Second: lots of discussion on noodle vs pink board vs styrofoam, and how much is required. One thread even talked about testing it. Has anyone tried sinking their boat yet? I'm not opposed to doing it at the launch ramp with the boat still connected to the trailer. I just don't see being able to stuff enough foam under there to keep her from going all the way down, but that's the debate.