1973 9.5 Johnson Armeture Plate Movment

Jgeisler

Recruit
Thread starter
Joined
May 25, 2016
Messages
3
I took the flywheel off my motor for a tune up and discover one the the points set needs to be replaced. I also notice the armeture plate has some play side to side that affects the point gap. Is this normal? If not, is there a solution, method for repair?
Thanks
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
Lack of lubrication and hrs of vibration can cause wear of the cast in place bushing.-----Yes it will affect operation of the points.------Availability of parts may depend on the number of used motors available in your area.---New plate $$$ may also be available.
 

kbait

Commander
Joined
Nov 13, 2007
Messages
2,488
You can likely fix by pulling the armature plate, and modifying the powerhead 'boss' it pivots on. Use a hammer and nail, and 'peen' the sides of that mounting boss at 12, 3, 6, and 9 o'clock. When you peen, you are raising a bit of metal from the boss, and by doing it at the four positions, you will evenly erase the lateral play. Start w/light peening, and check for fit. If there's still play, peen the exact same spots more, until all play is gone, w/ minimal radial resistance. Add a dab of grease to the peened spots, put it all together, set point gap to .020", and off you go!
Good luck.
 

F_R

Honorary Supreme Mariner
Joined
Jul 7, 2006
Messages
28,226
Make sure the cast-in-place brass bushing hasn't broken loose in the armature plate.
Make sure the retainer ring is right side up. It goes flat side up.
 

Jgeisler

Recruit
Thread starter
Joined
May 25, 2016
Messages
3
Did a tune up with new points and condensers and spark is good now on both cylinders. However no power under load...fuel delivery? Can anyone say what the ball on the fuel line should feel like? Sort of full or bulging tight? Could this be a sign of a faulty fuel pump? What else would cause an engine to slow cruise at WOT?
 

nabiul

Petty Officer 2nd Class
Joined
Jul 18, 2015
Messages
131
After you squeeze the primer bulb it should be firm before you start the motor. Once the motor is running the ball should become soft and limp.
Easy way to check fuel delivery, the bottom of the carburetor has a little screw sticking out at like 45 degrees towards the front of the motor, if you unscrew this fuel should pour out of the carburetors float bowl.

The fuel pumps only job is to fill the float bowl with gas, the float bowl is the actual reservoir that directly supplies the intake air with fuel.

As for what could slow you at WOT, maybe the high speed jet is clogged.
 
Top