1972 Johnson 85 hp electric shift

colewhitmore41

Cadet
Thread starter
Joined
Aug 13, 2016
Messages
6
I have a 1972 Johnson 85 hp electric shift that I discovered had no spark. I then discovered after looking around that one of the two wires coming from under the flywheel that connects into the white and black striped wire coming out of the amplifier assembly is corroded all the way through. What part does this wire lead to under the flywheel and how do I replace it.
 

F_R

Honorary Supreme Mariner
Joined
Jul 7, 2006
Messages
28,226
If it's been quite awhile since you have been into the points, it's time you do so anyway. The reverse cut-out ring certainly needs cleaning and re-lube. You may even find it ground to dust. The points don't burn out, but they do mechanically wear. Set them at .009-.010" Clean up the distributor cap too. When reinstalling the flywheel, make sure the tapers are clean and dry and use a torque wrench to tighten the nut to 100-105 ft/lbs. Don't guess at it.
 

F_R

Honorary Supreme Mariner
Joined
Jul 7, 2006
Messages
28,226
BTW, those are special wires, extra flexible to withstand the constant flexing back and forth.
 
Top