Hello all. I can use your help.
Im a newbie with some decent mechanical skills, but i,m dumbfounded with this 1971 Johnson 9.5.
Thanks to all your posts. I have got this far. now im stumped.
At first i wasnt getting proper spark from 1 plug. I tore the entire top end apart and cleaned everything up including the points.
I checked both the primary and secondary windings on the coils with Ohm meter. Both checked out. I then cut 1/4" from end of spark plug wire and reinstalled on both coils, because they looked a little corroded. Then set the points to exactly .020".
First Question: I read many posts about the timing. Is it true that as long as i have everything put together right, and the points are set at .020". that is the timing? Because i have both points opening and closing at .020" and closing completely.
I put the system back together then tested the spark. Spark is excellent. again , traced spark plug wires back to coils. they are on the right plugs. Good spark.
Cleaned the carb, and inspected all orifices. I took out the main high speed. cleaned everything with carb cleaner. orifices all are clean and unobstructed.Main looks like new.
I put it all back together and then tested the compression. around 63 PSI with fairly weak pulls. both the same. Seems solid.
Turned over the engine with gas line off outlet of fuel pump. Pumping sporadically like it should according to posts. took it apart anyways and inspected everything. Looks good. Made sure that it was together right. Retested. alls good
connected gas.
Should work, right??
Pumped the bulb until hard. Choked and with 1 pull started but was sputtering.
After about 15 seconds. It stopped completely and wouldnt restart after many tries. spark is still good.
Even tried a little Quick start. wouldnt run.
Help!!! I have about 20 hours into this thing which is in great condition.
I dont know what to do next?
Im considering taking it apart further and checking the reed valves, but thats a lot of work. Before i do. can I get some ideas of what to look for?
Thanks
Mike.
Im a newbie with some decent mechanical skills, but i,m dumbfounded with this 1971 Johnson 9.5.
Thanks to all your posts. I have got this far. now im stumped.
At first i wasnt getting proper spark from 1 plug. I tore the entire top end apart and cleaned everything up including the points.
I checked both the primary and secondary windings on the coils with Ohm meter. Both checked out. I then cut 1/4" from end of spark plug wire and reinstalled on both coils, because they looked a little corroded. Then set the points to exactly .020".
First Question: I read many posts about the timing. Is it true that as long as i have everything put together right, and the points are set at .020". that is the timing? Because i have both points opening and closing at .020" and closing completely.
I put the system back together then tested the spark. Spark is excellent. again , traced spark plug wires back to coils. they are on the right plugs. Good spark.
Cleaned the carb, and inspected all orifices. I took out the main high speed. cleaned everything with carb cleaner. orifices all are clean and unobstructed.Main looks like new.
I put it all back together and then tested the compression. around 63 PSI with fairly weak pulls. both the same. Seems solid.
Turned over the engine with gas line off outlet of fuel pump. Pumping sporadically like it should according to posts. took it apart anyways and inspected everything. Looks good. Made sure that it was together right. Retested. alls good
connected gas.
Should work, right??
Pumped the bulb until hard. Choked and with 1 pull started but was sputtering.
After about 15 seconds. It stopped completely and wouldnt restart after many tries. spark is still good.
Even tried a little Quick start. wouldnt run.
Help!!! I have about 20 hours into this thing which is in great condition.
I dont know what to do next?
Im considering taking it apart further and checking the reed valves, but thats a lot of work. Before i do. can I get some ideas of what to look for?
Thanks
Mike.
Last edited: