OK my Johnson model # 115ESL70D - when I torqued to 80 inch pounds the little o-rings #307853 for the four bolts on the propeller bearing housing, peeled off a little sliver of rubber on each one of the o-rings? are we sure about the 80-100 inch-lbs torque?
also I plan on installing new seals into the drive shaft thrust bearing housing, can you tell me what sealer I should use on the outside of the seals, and what lube on the rubber part of the seals? I read about special 3 way grease and special sealer that were both factory product, is there a good lube and sealant I can purchase from my local auto parts store I can use or that you recommend?