Hello everyone, I am looking for some help and advice. Recently my 1969 25 hp evinrude has had some trouble.
First, it had signs of a spun prop, so I marked the prop, and it was spun. So I replaced it. Next time out on the water, seemed to run fine, no spinning. So I went fishing for a bit. Boat had been sitting in the water for a couples hours. When I went to leave, I started heading back up the river, and noticed my engine would start to... "hiccup". That's the best way I can put it. I had it at WOT, and it would just keep having a little sputter or "hiccup", but would then keep going.
Just emptied my lower unit oil, and the oil was completely milky white, and pasty.
So, could this have caused it? Do i just need to replace some seals? Could there be more to it ?
Thanks for any help you can provide.
First, it had signs of a spun prop, so I marked the prop, and it was spun. So I replaced it. Next time out on the water, seemed to run fine, no spinning. So I went fishing for a bit. Boat had been sitting in the water for a couples hours. When I went to leave, I started heading back up the river, and noticed my engine would start to... "hiccup". That's the best way I can put it. I had it at WOT, and it would just keep having a little sputter or "hiccup", but would then keep going.
Just emptied my lower unit oil, and the oil was completely milky white, and pasty.
So, could this have caused it? Do i just need to replace some seals? Could there be more to it ?
Thanks for any help you can provide.