1968 johnson 20 horse...problems.

AlexE1436

Recruit
Thread starter
Joined
Jan 14, 2016
Messages
2
Hi guys, I've never posted before so I hope this is in the right place, anyways I bought an old alumacraft deep C and it came with a johnson 20 HP motor from 1968 and the previous owner said he never ran it in the two years he had it, I brought it home and it started right up, I replaced the impeller and lower unit oil and took it out and it ran great for a full day of fishing, the next time I took it out it wouldn't start, turns out there was a leaking gas line, so I replaced all the gas lines and put in a new kill switch, I took it out and it ran great for most of the day, towards the end of my fishing trip it made some sound almost like I hit something on the bottom of the river so I turned it off and pulled it up, and rowed away from where I was. When I started it back up and put it in the forward gear I could move forward but when I give it gas it will go a tiny bit faster and that anymore gas than that and it just sounds like I'm revving the engine, is this some sort of lower unit problem or is this a gear issue? Any ideas?
 

F_R

Honorary Supreme Mariner
Joined
Jul 7, 2006
Messages
28,226
Sounds like a spun prop hub. It is slipping like spinning your wheels on the ice. You may have hit something that caused it to break loose just then.
 

AlexE1436

Recruit
Thread starter
Joined
Jan 14, 2016
Messages
2
I'll check that out, if it isn't could it be something in the lower unit?
 
Top