Hi everyone. This is my first post and I'm looking forward to hearing back from the knowledgeable community here. I've been browsing the site over the last few weeks and it really seems like it's "the" place to go. Very nifty!
I've got a 1966 Evinrude Lark viii 40hp engine in a little glass runabout that I'm getting ready for water. It's got the Selectric shift gearcase. The previous owner said it had trouble shifting into reverse and that the gearcase leaked oil. A bit of Web searching told me it was going to be trouble, but I love a good challenge so I dove into it. I got the engine going and it runs quite nicely but yes, no shifting to reverse. Fine then - I bought he correct factory service manual for it and took the lower unit apart. All the seals are bad and the proper coil power cable has been replaced wih just two wires and a mess of silicone. It wasn't hard to figure out where he water was getting in. Haha.
Well I'm already getting blabby so I'll get to the point. The mechanicals are in surprisingly good condition for having had water in there. The trouble is with the reverse coil - it's been rubbing the gear/spring carrier and is totally shot. This part seems to be pretty rare and expensive. I can find the forward coil no problem but that reverse coil not so much. From measurements I have taken it appears that the two coils are identical except that the reverse coil is pressed (or otherwise afixed) into an outer housing that has the four tapped holes into which the final bearing carrier or "gearcase head" bolts to.
My question is this: do I need to scour the earth for the rare proper part number reverse coil assembly or can I use a quite reaily available new forward coil and press it into the old reverse housing? OMC seems like a pretty savy manufacturer that wouldn't likely, in the interest of profit, make two distinctly different coils for this application. I'm going to make this happen one way or another even if I have to build my own coil, but I'm curious if anyone has any knowledge on this subject.
Thanks for listening, and thanks in advance for any and all responses good or bad.
I've got a 1966 Evinrude Lark viii 40hp engine in a little glass runabout that I'm getting ready for water. It's got the Selectric shift gearcase. The previous owner said it had trouble shifting into reverse and that the gearcase leaked oil. A bit of Web searching told me it was going to be trouble, but I love a good challenge so I dove into it. I got the engine going and it runs quite nicely but yes, no shifting to reverse. Fine then - I bought he correct factory service manual for it and took the lower unit apart. All the seals are bad and the proper coil power cable has been replaced wih just two wires and a mess of silicone. It wasn't hard to figure out where he water was getting in. Haha.
Well I'm already getting blabby so I'll get to the point. The mechanicals are in surprisingly good condition for having had water in there. The trouble is with the reverse coil - it's been rubbing the gear/spring carrier and is totally shot. This part seems to be pretty rare and expensive. I can find the forward coil no problem but that reverse coil not so much. From measurements I have taken it appears that the two coils are identical except that the reverse coil is pressed (or otherwise afixed) into an outer housing that has the four tapped holes into which the final bearing carrier or "gearcase head" bolts to.
My question is this: do I need to scour the earth for the rare proper part number reverse coil assembly or can I use a quite reaily available new forward coil and press it into the old reverse housing? OMC seems like a pretty savy manufacturer that wouldn't likely, in the interest of profit, make two distinctly different coils for this application. I'm going to make this happen one way or another even if I have to build my own coil, but I'm curious if anyone has any knowledge on this subject.
Thanks for listening, and thanks in advance for any and all responses good or bad.