1966 evinrude 9.5hp sportwin

luke55

Recruit
Thread starter
Joined
Apr 8, 2018
Messages
1
Does the powerhead need to be removed to re-install the water supply tube or can it be installed from below the powerhead?
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
Yes , the right way to do it is to remove the powerhead.-----It is held in place at the top and should stay up there when lower unit is removed.-----Removing the powerhead is not for the faint of heart.
 

Crosbyman

Admiral
Joined
Nov 5, 2006
Messages
6,298
with patience.... could it be shoved ... guided up into the ph ??

how about removing it from the pump end guiding up into the PW with a small thin rod inserted in the water inlet to guide the tube into the pH.. followed by the pulling back of the guide rod ???

need to know for my 9622a :rolleyes:
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
I am sure that many folks have put it back up without taking the powerhead off.
 

RCO

Petty Officer 1st Class
Joined
Jun 15, 2016
Messages
350
It is doable without removing the powerhead if you are patient . It is easiest if you set the motor upside down on a couple of wood blocks .
 
Top