1965 Evinrude 9.5 wont start

glick

Cadet
Thread starter
Joined
Jul 25, 2015
Messages
13
Hello,

This is my first post here but I have already learned quite a bit from searching and reading, so thanks in advance!

I have a 1965 Evinrude 9.5 that will occassionally start, run for a minute or so, then cut off. Sometimes it wont start at all. The engine has compression of approx. 60 psi in each cylinder and does have spark on both cylinders. I have already replaced the points, condensers, ignitions wires and boots, and the spark plugs. I have also rebuilt the carburetor, and the fuel pump is reasonably new and does function. I bought this motor used and have no idea when the last time it actually ran was. Also, this afternoon it wouldn't even turn over with starter fluid. Is there something that I could have overlooked or something that I am missing here?

Thanks so much for the help

Glick
 

HighTrim

Supreme Mariner
Joined
Jun 21, 2007
Messages
10,486
What is your starting procedure step by step?

How did you test for spark?

Is fuel getting to the plugs? After attempting to start, pull them, are they wet? If you spray pre mixed fuel into cylinders, will it start for a second?

PS, don't use starting fluid on a motor. Use pre mixed fuel in a spray bottle.
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
Answer this question.-----------Does spark jump a gap of 1/4" or more with a snap you can hear ?------Laying plugs on the block is not a good test !!
 

glick

Cadet
Thread starter
Joined
Jul 25, 2015
Messages
13
Hello, and thanks for the quick reply!

Spark will jump a 1/4" gap on a spark tester but not on every pull. Also, I actually did have it starting regularly on the third pull earlier today. The only thing is is that it would only start with the throttle advanced all of way with no choke, and it would not slow down when I tried to throttle back. It would just die. I did not know not to use starter fluid! lesson learned.

My start-up proceedure is: pump fuel ball until firm, close the choke, advance throttle slightly, then pull the cord.

I appreciate the help.
 

glick

Cadet
Thread starter
Joined
Jul 25, 2015
Messages
13
Hello,

So I figured out my throttle problem, but now I am working on the weak spark. I have replaced all of the magneto components and am still only having intermittent spark. I have watched numerous videos and read many blogs and articles regarding the magneto and am dumbfounded as to why I don't have better spark.
 

glick

Cadet
Thread starter
Joined
Jul 25, 2015
Messages
13
Update: I began switching magneto components from the good spark side to the bad and found that one of the new coils does not function! Go figure... I guess I'll try switching the bad one with one of the originals and see what happens.
 

glick

Cadet
Thread starter
Joined
Jul 25, 2015
Messages
13
Well I got it running well enough to actually take it out today! The new coil was shot. Only issue to work through now is that is will only run with the choke on. When I open the choke the engine smooths out but then bogs and dies.
 
Top