1960 5.5 evinrude restoration

doug w

Cadet
Thread starter
Joined
Jun 30, 2018
Messages
6
Need some expert direction please. I recently purchased a 5.5hp evinrude which has sat for some time. Compression is good but does not run. I began by rebuilding carb and replacing fuel lines and plugs. Had engine running for about 30 seconds and have not been able to restart since then. I also noticed excess gas sitting in carb opening in front of butterfly valve. I then removed carb and checked float valve and all gaskets and seals which looked ok. Still unable to start



Suggestions please? I have new ignition parts to install but since the motor ran I suspect there is a problem with fuel system



Thank you



Doug
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
Remove recoil.-----Remove the inspection plate.----Look at coils.----They are either new or both are cracked.-----Every body picks the carburetor to work on / blame.----It is weak spark that is the major issue in " no start " conditions.
 

doug w

Cadet
Thread starter
Joined
Jun 30, 2018
Messages
6
will do - thought it might be part of the issue. Another question... The throttle markings for start stop and run are missing. Do you know where the start position on throttle is or how much to turn throttle?

Thank you
 

F_R

Honorary Supreme Mariner
Joined
Jul 7, 2006
Messages
28,226
Advance the throttle till the carb just starts to open for a starting position.

racerone is 100% correct. Everybody assumes it is carburetor trouble, when it usually is not. We see it here on the forum every day.
 

doug w

Cadet
Thread starter
Joined
Jun 30, 2018
Messages
6
thank you guys

will report back after ignition parts are replaced
 
Top