1956 Johnson Javelin 30 first start weird question

highdesertboating

Recruit
Thread starter
Joined
May 2, 2016
Messages
4
So I went through and rebuilt the carb, new points and condensers, plugs, checked compression and new water impeller and am ready to try starting it up for the first time. I've got all the wiring done to the electric choke and starter button redone, new battery cables and all. Here's the question though. How do I turn off the engine if it starts up? It didn't come with a key like my newer outboards have, and there isn't any obvious button that says off on it. im confounded, this is my first older outboard.
 

lindy46

Captain
Joined
Nov 27, 2008
Messages
3,886
Those motors didn't have a kill circuit. You just choke to shut it down.
 

oldboat1

Fleet Admiral
Joined
Apr 3, 2002
Messages
9,612
I like to check for spark before test running it -- can do that using a spark tester (plugs out, spin the flywheel clockwise by hand). Spinning it "smartly," should get a strong spark maybe 1/4 or 3/8 inch -- or use the pull starter. Then like to check the carb needles for their initial positions (about 1 turn out from seated for the l.s. needle, maybe a little more, and about 3/4 turn for the h.s.) When firing it up, I like to do it with the cover off so I can check head temperature. You should get a good spray of water from the port on the back of the leg right away. Sink the leg about half way up -- has to be good and deep. Check for water flow, then let it warm up a little and adjust the needles (If she fires and runs, adjust for leaner setting first -- clockwise. Rpms should increase as you lean it out. Back out about 1/4 turn if you get lean sneezing. The throttle idle stop screw is the plastic screw at the bottom of the throttle tower -- can set it to hold a slow idle speed, or back it out to the point the engine will stall when you throttle it way down (another way of stopping it). I like the choke method like Lindy suggests.

[ed. If you Really have it tuned in, it might not shut down even when the throttle stop is fully backed out! Just putts along nice and slow.... Should add the adjustments should be made with engine warmed up and in gear.]

Fun stuff.
 
Last edited:

lindy46

Captain
Joined
Nov 27, 2008
Messages
3,886
Just add a kill circuit.My 56/30 had one ,worked great.

Yup, just add a wire to each of the points (where the other wires connect) and at the other ends install a push button to close the circuit.
 

highdesertboating

Recruit
Thread starter
Joined
May 2, 2016
Messages
4
That should have been obvious. I just went and looked at the metal dash plate. "Push Choke to Stop" is written right on the start/choke button plate right under the buttons. I guess I should have looked. Thanks guys!
 
Last edited:
Top