Maddison III
Cadet
Thread starter- Joined
- Mar 9, 2016
- Messages
- 6
Bought a wooden 1955 Bowman Rascal w/ original 1956 Evinrude 30hp Big Twin and original trailer. I have the service manual, and other guides from the net. I cannot yet post pictures, so please bare with me. So far, I have completed the following on the motor: Rebuilt carb, new coils/points/condensors/plugs/wires, new fuel/air lines, new water impeller, and new lower unit seals. I have two questions:
I cannot identify the vaccum?/fuel? port directly (approx 1 inch) aft of the carb filter bowl. I reassembled everything as it was the way I aquired it (which may not be right), and as far I can tell, correctly based on various schematics. Fuel and air is hooked up with new lines, this third mystery port did not have anything attached, and I can not find it in any schematics. What is it?
When replacing the water impeller (has been replaced before), a woodruff key fell out. The drive shaft has a pin on it and no indentation for a woodruff key. I've seen schematics with a key, and another one with just the pin (no woodruff key). I did not see where it was installed, and it will not fit in the impeller because the shaft does not have a slot for it. Does the impeller supposed to have a woodruff key, and if so where does it go?
Thanks in advance
I cannot identify the vaccum?/fuel? port directly (approx 1 inch) aft of the carb filter bowl. I reassembled everything as it was the way I aquired it (which may not be right), and as far I can tell, correctly based on various schematics. Fuel and air is hooked up with new lines, this third mystery port did not have anything attached, and I can not find it in any schematics. What is it?
When replacing the water impeller (has been replaced before), a woodruff key fell out. The drive shaft has a pin on it and no indentation for a woodruff key. I've seen schematics with a key, and another one with just the pin (no woodruff key). I did not see where it was installed, and it will not fit in the impeller because the shaft does not have a slot for it. Does the impeller supposed to have a woodruff key, and if so where does it go?
Thanks in advance