1956 15 hp Evinrude fuel pump upgrade

i4get

Cadet
Thread starter
Joined
Mar 29, 2010
Messages
8
Hi guys

I inherited a 1956 15 hp Evinrude 15016 and it has been converted to a fuel pump system in the past. There is fuel line going to the pump which is mounted just behind the upper cylinder. Then there is a fuel line from the pump to the fuel bowl on the carb. What I can't figure out is what the short hose is coming from the back of the motor. Could this be what is left of the return hose for the original pressurized system? If so, should this line be plugged since the system has been converted?
Thanks.
 

mettyfish

Petty Officer 2nd Class
Joined
Jul 3, 2007
Messages
180
Re: 1956 15 hp Evinrude fuel pump upgrade

probably the line for air to pump the diaphram. need a line for fuel to pump. pump to carb. and a line for air to run pump. hope this helps. good luck
 

ovnic1234

Seaman
Joined
Dec 6, 2008
Messages
69
Re: 1956 15 hp Evinrude fuel pump upgrade

You are correct, the mystery hose supplied the pressure to the old style tank. It should be coming out from the manifold under where the carb mounts. Cap it off how you see fit. I believe there is a post on here describing a conversion of a late 50's 18hp which employed the same approach. The pulse and vacuum is supplied through the bypass cover on which the fuel pump is mounted on. Enjoy
 

i4get

Cadet
Thread starter
Joined
Mar 29, 2010
Messages
8
Re: 1956 15 hp Evinrude fuel pump upgrade

Thanks guys.

If it is not capped off, will that effect how the motor runs? Is it essential this line be plugged? The motor runs, but only with just about full choke and it won't idle too good. I'll look for the thread you describe for the 18 hp conversion, as well.

Thanks again!
 

1946Zephyr

Vice Admiral
Joined
Oct 21, 2008
Messages
5,556
Re: 1956 15 hp Evinrude fuel pump upgrade

If it is not capped off, fuel mix will spray all over in your motor cowl, therefore creating a fire hazzard. The best thing to do is remove the nipple that is there and replace it with a plug, so there is no possibility of fuel leaking out there at all.:cool:
 

tootallofwa

Petty Officer 2nd Class
Joined
Feb 20, 2010
Messages
180
Re: 1956 15 hp Evinrude fuel pump upgrade

It's my understanding that the two line system worked by pumping air in to the tank forcing fuel to the carb.

later fuel pumps worked using a vacuum/pressure pulse from the bypass covers. (crankcase pressure)

the line you found behind the carb should be vacuum only from the intake manifold (Isolated from pressure by the butterfly valve.)

I have such a line and it connects to a cut out switch.

A vacuum leak of any kind will make your engine run rough or not at all.

GL;)
 
Top