I was in the final stages for getting an old 1961 18hp Johnson finally up and running including a rebuilding the carb, adjusting points, new lower unit lube and a new fuel pump and adding a new impeller. I took it out today on the river and DID NOT make sure the water was spitting out the back. I can not believe that I forgot to check after replacing the impeller!! I am kicking myself as I have spent many hours getting this old beauty up and running. I am guessing I did not line up the rubber grommet to the copper tube?? I have not yet removed the lower unit to see ..
The motor did seize up on the water. I got it home took the plugs out and poured some 2 stroke oil down the plug holes and the motor freed up with almost no effort. Next I tested the compression and was disappointed to see the top cylinder was only registering 30 PSI and the lower was registering 90 PSI. I tested them a recently and they both registered over 100 PSI.
So my question is ... what would you do? Should I simply add new head and exhaust gaskets? Or do a complete tear down? Or find a good used powerhead with good compression? Or something else?
Thanks in advance for your advice!!
The motor did seize up on the water. I got it home took the plugs out and poured some 2 stroke oil down the plug holes and the motor freed up with almost no effort. Next I tested the compression and was disappointed to see the top cylinder was only registering 30 PSI and the lower was registering 90 PSI. I tested them a recently and they both registered over 100 PSI.
So my question is ... what would you do? Should I simply add new head and exhaust gaskets? Or do a complete tear down? Or find a good used powerhead with good compression? Or something else?
Thanks in advance for your advice!!