18hp Johnson Overheated ... Compression 30/90 .... What would you do?

wadeatl

Cadet
Thread starter
Joined
Jun 8, 2007
Messages
8
I was in the final stages for getting an old 1961 18hp Johnson finally up and running including a rebuilding the carb, adjusting points, new lower unit lube and a new fuel pump and adding a new impeller. I took it out today on the river and DID NOT make sure the water was spitting out the back. I can not believe that I forgot to check after replacing the impeller!! I am kicking myself as I have spent many hours getting this old beauty up and running. I am guessing I did not line up the rubber grommet to the copper tube?? I have not yet removed the lower unit to see ..

The motor did seize up on the water. I got it home took the plugs out and poured some 2 stroke oil down the plug holes and the motor freed up with almost no effort. Next I tested the compression and was disappointed to see the top cylinder was only registering 30 PSI and the lower was registering 90 PSI. I tested them a recently and they both registered over 100 PSI.

So my question is ... what would you do? Should I simply add new head and exhaust gaskets? Or do a complete tear down? Or find a good used powerhead with good compression? Or something else?

Thanks in advance for your advice!!
 

ondarvr

Supreme Mariner
Joined
Apr 6, 2005
Messages
11,527
If it seized, then there's damage to the pistons and cylinders that needs to be repaired. Had it not seized, then you may have gotten away with just a new head gasket.
 

ondarvr

Supreme Mariner
Joined
Apr 6, 2005
Messages
11,527
Pull the head off and see how bad it is, then make a plan from there.
 

F_R

Honorary Supreme Mariner
Joined
Jul 7, 2006
Messages
28,226
When you get the exhaust covers off, you will be able to see the piston skirts and check for scoring. If they are not scored, buy a lottery ticket because this is your lucky day. Then replace exhaust gaskets & head gasket and get on with life. But if they are scored, need we say more?
 

oldboat1

Fleet Admiral
Joined
Apr 3, 2002
Messages
9,612
Aw, maybe don't need a huge lottery win, though. That powerhead is pretty easy to find. I think the '61 motor might be a little rare ('61 Lark 40s, anyway, I think). But a replacement 60s or 70s p.head could be had. Think I would look for a complete parts motor -- good compression, but otherwise don't have to be too fussy (JMO).
 

wadeatl

Cadet
Thread starter
Joined
Jun 8, 2007
Messages
8
Thanks guys ... I will pull the covers off and see what it looks like. I am not too optimistic.

I'll start looking to see what if I can find a deal on a complete parts motor. What year of powerheads should I be Iooking for if I can not find a full motor.
 

oldboat1

Fleet Admiral
Joined
Apr 3, 2002
Messages
9,612
22 cube 18 - 20 hp, '60s through about '75. probably others. I would start with early to mid-60s J&E parts motors, and take it from there. Spring is a time for garage sales.
 
Top