water in bottom starboard cylinder.replaced head gasket. water still in bottom cylinder. HELP!!!!!!
C chipley Recruit Thread starter Joined Feb 2, 2017 Messages 4 Feb 3, 2017 #1 water in bottom starboard cylinder.replaced head gasket. water still in bottom cylinder. HELP!!!!!!
C chipley Recruit Thread starter Joined Feb 2, 2017 Messages 4 Feb 3, 2017 #3 thanks. when I replaced the head gasket, I hand turned the crank and water seemed to enter from exhaust ports
thanks. when I replaced the head gasket, I hand turned the crank and water seemed to enter from exhaust ports
R racerone Honorary Supreme Mariner Joined Dec 28, 2013 Messages 40,028 Feb 3, 2017 #4 Is this a jet unit ?
C chipley Recruit Thread starter Joined Feb 2, 2017 Messages 4 Feb 3, 2017 #5 yes,1994 sunbird 115 jetboat
R racerone Honorary Supreme Mariner Joined Dec 28, 2013 Messages 40,028 Feb 3, 2017 #6 Remove / inspect the exhaust covers.-----Saw that inner exhaust manifold cracked on one of these units.
Remove / inspect the exhaust covers.-----Saw that inner exhaust manifold cracked on one of these units.
C chipley Recruit Thread starter Joined Feb 2, 2017 Messages 4 Feb 3, 2017 #7 thanks very much. will post result.
Bosunsmate Admiral Joined Apr 7, 2012 Messages 6,135 Feb 3, 2017 #8 yes and put a straight edge on them to make sure they arent warped. Seen it myself
R racerone Honorary Supreme Mariner Joined Dec 28, 2013 Messages 40,028 Feb 4, 2017 #9 What / when / where did this water intrusion occur ?------Was motor running on a hose ?----Was hose running and motor stopped at any time ?
What / when / where did this water intrusion occur ?------Was motor running on a hose ?----Was hose running and motor stopped at any time ?
E emdsapmgr Supreme Mariner Joined Dec 9, 2005 Messages 11,551 Feb 5, 2017 #10 If the engine ever overheated, the manifolds may warp and not lie flat on the exhaust filler blocks . Water can enter there under pressure. Does the outer manifold need to be re-torqued?
If the engine ever overheated, the manifolds may warp and not lie flat on the exhaust filler blocks . Water can enter there under pressure. Does the outer manifold need to be re-torqued?