Search results

  1. slimdaddy45

    Cavitation plate

    Why if its dry and good shape no more than I took out of wet probably wouldnt make much difference if it was left out only about a foot square piece was wet there is alot in this boat but I will replace it
  2. slimdaddy45

    Cavitation plate

    As of right now I got the floor out of it to replace it found wet foam right at the back o n the drivers side the rest is dry so Ill probably leave the good dry foam havent got the other side out yet .My motor is probably 2'' high and will that cause it to wash back n forth at low speeds i...
  3. slimdaddy45

    Cavitation plate

    Hi guys I have a 19.5' Sea Nymph SS195 I have an old 1974 Johnson 115 hp on it and sitting on a CMC tilt unit which gives you around a 6'' setback so where should I set the cavitation plate at from the bottom of the boat to be right or close for best performance has a 13.75 x 15 prop on it...
  4. slimdaddy45

    Prestone Flush

    Try some CLR i FLUSHED MY TRUCK CAUSE MY HEATER WASNT WORKING VERY GOOD AFTER THE FLUSH i HAD GOOD HOT HEAT OUT OF IT SO IT WORKED FOR THAT
  5. slimdaddy45

    1974 115 idle problems

    Got an old 74 Johnson 115 it will idle grat when the engine has cooled off but after running down the lake and you shut it off then restart it don't wanna idle keeps dying what could it be motor runs great otherwise just don't wanna idle after being hot
  6. slimdaddy45

    Help with prop size and setback of motor

    oiK I bought a Sea Nymph SS195 19.5' boat with a seized 88 hp Johnson which had a 13x 19 prop with t x t so Took a motor off my other boat which is a 1974 115 hp and put it on a CMC aftermarket T & T IT HAD A 13.75 X 15 PROP SO SHOULD I RUN THE 13 X 19 AND WITH THE SETBACK[ 5.5''], FROM...
  7. slimdaddy45

    Transom Thickness on a Sea Sprite tri-hull

    Nice looking old boat for a 74 model
  8. slimdaddy45

    Transom Thickness on a Sea Sprite tri-hull

    I need to replace the transom in my boat it has a 1'' wood core but I read that everybody puts 1 1/2 '' in should I do this or leave it at 1'' which would be close to 1 1/.2 with the outer & inner skin its on a Seas Sprite tri-hull if I go thicker not sure if the cap will fit the way the...
  9. slimdaddy45

    Water Problem 74 Johnson 85 Hp

    just bought this thing when running with the ear muffs on water comes out everywhere comes out where lower unit bolts on and a couple little holes on the front and left side whats the problem can anybody help me plz
Top