Search results

  1. R

    BF150D where to connect small connector on control wires at motor?

    Well, if anyone finds themselves in my position, just wanted to share that the shop did sell me the wrong harness. The 2023 or 2024 BF150 takes a new harness that has a square connector. Kicking myself for not double checking but I assumed the shop ordered the right parts.....you know what...
  2. R

    BF150D where to connect small connector on control wires at motor?

    To update this post- I think the question comes down to what main wiring harness (going from ignition to motor) is needed for the Honda BF150D BBTJ-1005448. The mechanic gave me 32205-ZY6-020AH to install. There are two connectors on the motor side of the harness. The small 6 pin doesn't seem...
  3. R

    BF150D where to connect small connector on control wires at motor?

    I am installing a new BF150 on my striper1851. I have been unable to purchase a current rigging manual for the job - Honda doesn’t have them in stock- so it’s been a bit frustrating. I am stuck on what seems like it should be the easiest thing ever, connecting the smaller 6 pin connector of...
  4. R

    Strange Stalling Problem in E115FPXEEC

    1999 Evinrude 115 Ficht E115FPXEEC The engine stalls just as I begin to throttle up, in forward or reverse. It fires up just fine, idles just fine, idles in gear just fine, then just as I begin to throttle up is stalls. So far it has only happened about 3 times in 10 outings. My solution has...
  5. R

    So close....Evinrude Ficht stalls above idle

    My evinrude 115 1999 ficht (e115fpxeec) stalls when the throttle advances above idle (disengaged). I posted earlier on this and went down the path of spark plugs. I am going to replace the plugs tomorrow, but I don't think that is the main problem. I checked it again tonight and it is a very...
  6. R

    Wrong plugs causing stalling in Evinrude 115 FICHT?

    Evinrude 115Hp 1999 FICHT (E115fpxeec) My mechanic put Champion 7112 plugs in. It runs ok at idle, but stalls when I advance the throttle (disengaged). If I punch it past the stall point it will rev up and run fine. If I return the throttle quickly to idle position, it will come back and...
  7. R

    Evinrude 115 FICHT: Backfires and Rough

    I have a E115fpxeec 1999 115hp evinrude ficht. I just started it up to test it after replacing the low pressure fuel pump diaphragm. It was not good. It revved higher than it should. Sounded like it was missing a cylinder or two then stuttered and backfired a number of times and stalled. I...
  8. R

    Evinrude 1999 Ficht 115hp fuel pump diaphragm

    I have a E115fpxeec 1999 115hp evinrude ficht. The low pressure fuel pump diaphragm has a whole. I cannot find the kit anywhere, it is obsolete and unavailable. Anyone know where I might have luck or if there is another kit that would work? Also curious if anyone knows where I can get the...
  9. R

    Which Evinrude 115 1999 injectors?

    Engine: Evinrude 115 ficht 1999 (E115FPXEEC) I have my engine into a very reputable mechanic. I need new injectors. Every site online states that I need injectors 5000770 however the mechanic insists I need 5004477. I know these injectors had a lot of trouble, including fire hazard, anybody...
  10. R

    Mechanic cannot read diagnostics on 115 FICHT

    Engine: E115FPXEEC He replaced the connector and still had no luck. I am wondering if the computer is shorting out or something that is also making it run rough. Has anyone had experience like this? The last work they did, they pinched the trim wires in the cowling so I am wondering if they...
  11. R

    Fuel Delivery Problem on 115 FICHT

    This problem has some history so here are some pertinent details and chronology of problem: Engine: E115FPXEEC End of June, I got water in the fuel and it got past the water/fuel separator in the engine and stalled. I drained some and took it into the shop and they cleaned the water from the...
  12. R

    Evinrude 115 Ficht 99 Water in Fuel

    I have a 1999 Evinrude 115 Ficht (E115FPXEEC). I recently got a bunch of water in the fuel when the bilge went over the fuel tank and the sender or pickup gasket failed. When the alarm originally went off, I thought it was a different problem and idled toward the harbor with the engine running...
  13. R

    15 hp overheating after impeller replacement

    I have an evinrude 15hp 1998 outboard (E15RCEC). I replaced the impeller, but not the water pump. On test using the hose everything seemed to be fine with the indicator showing strong. I took it out on the lake and a quarter of a mile out, I noticed that it seemed very hot. The pee stream...
  14. R

    Cough coming out the Carb 120 hp Evinrude

    I have a 120 hp Evinrude Outboard 1994. I fired it up to check on it before the fishing season. This thing always has run a little rough and especially coughs a lot on startup. I had the carb covers off and I noticed on at one point that exhaust or fuel spray came out of the carb during a...
  15. R

    Oil Leaking into Fuel Line when Stored

    I have a 1994 Evinrude 120hp. I am having trouble with it accumulating oil in the fuel line (and possibly the carbs) when it is being stored for a week or more. Symptoms are an extremely smokey and rough start that I can get through and then it runs fine. BUT it can take awhile and it is...
  16. R

    Screw stop under flywheel 120hp evinrude

    What is the name of the screw stop located on the port side just under the flywheel in a 1993 120 hp 4 cylinder evinrude? (I have gone through the manual over and over, but I just can't find a picture of it) My engine has been having trouble idling and I noticed that the bracket holding the...
  17. R

    dirty fuel before pump- bad VRO?

    I have a 1993 120 hp 4 cylinder Evinrude. 1) It started incredibly dirty. (I have had this engine for years and run it for hundreds of hours and it has never come close to this) 2) After many starts and short idling before stalling it finally pushed through it and ran more cleanly. 3) I...
  18. R

    test prop

    I am looking for a test prop for my evinrude and cannot find it on iboats. OMC part: 433068. anyone know where I can find one. Also curious if it is necessary. Its my understanding that its needed for max spark advance. Do people do it without a test prop? thanks
  19. R

    Seaking-what year?

    I just got a 15hp seaking. model vwr52119, serial # 97X20892. 1) what year is this? (from other posts, I gather it to be from 1981-83) 2) What carb kit should I order? (Iboats has 4 different 15hp kits- not sure the distinction and I don't have the manual yet- will order once I know the...
  20. R

    Evinrude 120 stalls out- link and sync?

    I have an Evinrude 4-cylinder 120hp 1994. The engine ran poorly, stalling, coughing. I thought is was a carb issue so I cleaned all carbs twice over, then determined that it was the power pack. When I replaced the powerpack it ran great out of the water, but in the water stalled at idle...
Top