Search results

  1. T

    Fuel Filter 2003 Johnson 90

    While I was squeezing the primer bulb today, I had the fuel filter blow out completely allowing fuel to pour out of the fuel line. Was surprised because it is held in place by a large plastic nut. Anyone else ever heard of this? Also, anyone else running SEAFOAM regularly in their fuel?
  2. T

    Stereo

    I am going through stereos about every 5 months or so. I have been purchasing the automotive type from Wally World...I do have a water-proof cover on the front of course. I even keep a water proof cover on top of my center console, but I seem to be losing the sound card every 5 or six month...
  3. T

    Hydraulic Steering

    I have a 16' McKee Craft CC with a 2003 90 hp Johnson Motor. I noticed my steering was getting stiffer and stiffer, and the boat was not much fun to drive anymore. It was just hard to maneuver period. I was going to need a new cable and a new anti-feedback helm control. When I priced...
  4. T

    Hole in 1999 Bennington Pontoon

    So I am driving my pontoon boat back to the storage area where I keep her. I was following a lawn service trailer...when all of a sudden a 3ft metal pipe falls off the trailer and starts flipping along the road. I swerved my new 2013 F150 truck to avoid the pipe; unfortunately, I ran over the...
  5. T

    1999 bf40 beep-beep-beep-beep

    Horn started beeping at initial start-up....did not stop until I pulled a wire on the horn. Boat ran great all day long....New water pump pumped great all day long, did not overheat. Fresh oil change...plenty of oil. Does anyone have an idea of what could be causing this horn, or where I need...
  6. T

    2003 Johnson 90 (Bombardier)

    Noticed the oil was getting a little low, so I topped it off with a fresh gallon of synthetic (at the house) before I left. I put the boat in the water, and the motor cranked right up. Idled out into the channel...all of a sudden I get a constant horn with the "NO OIL" light on my systems check...
  7. T

    Honda BF40 Idle issues- Please help me if you can.

    I just inherited my Dad's old VERY VERY low hour 1999 Honda BF40. The motor was used very little the past four years, and it did sit quite a while. I now have the boat and motor in Florida going through it. I have a aggravating miss at idle. So far I have: 1. Changed Impeller 2. Changed...
  8. T

    1999 Honda BF40

    Here is an update on my Dad's old pontoon with a very low hour Honda BF40 Outboard. The boat spent almost all its life in a fresh water like in Kentucky...under a boat house. In fact, the boat had only been out of the water twice in 15 years...both times to perform routine maintenance when I...
  9. T

    Pontoon Siding Replacement

    Here is an update on my Dad's old 1999 Bennington Pontoon. My dad died in October and left me his prized pontoon boat. It looks like Dad had a few encounters with the rocks (and boat dock) at his fresh water lake in Kentucky. His eyesight was failing, so his depth perception was kinda off a...
  10. T

    1999 Honda BF40 Question

    Hello to all in HONDA Forums, I am new to your side of the forums, but I am a regular on the Johnson/Evinrude and Mercury side. . I am now a proud owner of a 1999 Honda BF40. My Dad recently died and left me his Bennington Pontoon boat which I have taken care of for years. I pulled this...
  11. T

    1999 Bennington 18.5 Pontoon

    My Dad died two weeks ago and left me his nearly mint condition pontoon boat. He lived on a lake in Kentucky, so the boat has never left his boat-house. This boat has very very few hours. Over the years, I performed the maintenance myself, so I know the boat very well. Here is my question...
  12. T

    Engine won't turn bigger prop

    Mr. Moderator. I did post this same question in the "Props" section of this forum Please don't be too angry with me. I have a 2003 Johnson 90 (Bombardier) V-4 mounted to a 17 ft McKee Craft CC Boat. 20 Gallon gas tank mounted under console. Motor runs great, idles great....no issues at all...
  13. T

    Question

    I have a 2003 Johnson 90 (Bombardier) V-4 mounted to a 17 ft McKee Craft CC Boat. 20 Gallon gas tank mounted under console. Motor runs great, idles great....no issues at all. However, To get the motor to run in the 5500-5800 RPM range, I can only turn a 14 x 13 pitch prop. Everyone says...
  14. T

    OMC Lower Unit Identification

    Today I went to a local resale shop, and I could not believe my eyes. There before me was a GREAT-looking, Extremely clean OMC Lower unit.... factory painted black. I immediately thought : Johnson Tracker Lower unit....obviously OMC. The owner of the shop knew nothing about it. He said it...
  15. T

    What Prop do I need?

    I am trying to figure out which is the correct prop for my boat. I have tried a couple of different props for testing before I make the investment in a new SS Prop. I am hoping one of the "Prop Experts" will jump in and give me a hand. Here is what I know so far: Testing was done with full...
  16. T

    2003 Johnson 90 Lower Unit Leak Solved....I Think

    Hello to all, I am the guy with the leaking Lower unit. I replaced the prop shaft seals, the drive shaft seals, the shift rod O ring and gasket, and the crush washers on the fill screws. The Lower Unit passed a vacume test, and a pressure test so I filled the unit with Pennzoil MARINE 80/W 90...
  17. T

    Lower Unit Oil looks like Honey Mustard Salad Dressing

    Hello to all, I am the guy with a 2003 Johnson 90 (Bombardier) I am going to cut to the chase. After replacing the drive shaft seals, the prop shaft seals, and the the filler screw crush washers, my lower unit is still taking in water from some place. Vacume testing holds all day at 10-12...
  18. T

    2003 Johnson 90 Lower Unit. PLEASE, I need input.

    Good evening to all. Today was a big day for me. FINALLY, I was able to put my baot in the water with a new-to-me motor. Switched from a Mercury 70 to this Johnson 90. The power of this motor is unreal compared to the old Mercury. My old McKee Craft was flying, and the hole shot was...
  19. T

    How much Oil?

    I am finally finished rigging my new-to-me 2003 90 HP Johnson. I have decided to use the Oil Injection system this Bombardier was designed to use. I have taken some advice and pre-mixed a (50-1) 6 Gallon tank and running this tank along with the Oil Injection to confirm the system is indeed...
  20. T

    2003 Johnson 90 - Decision Time

    As some of you know, I have been rebuilding my older McKee Craft. I have been De-Mercurying the hull, and gearing up for a new to-me Johnson 90 with very low hours. Finally, I am ready to install the motor this weekend; however, I have a decision to make. Do I rig for the oil injection or...
Top