The iboats forum moderators are excited to announce that at this time it appears the iboats forums posting pictures function is working once again. Though we cannot promise for how long, we're hoping for indefinitely.
I put a remanufactured carb on less than a year ago. New filters have less than an hour if even that. I need to take it out and do some adjustments since I was having problems with the fuel delivery. I am also going to check the advance in the distributor.
Well got the one issue of it running out of fuel, replaced the water seperator. But now the boat runs great at part throttle but as you open it up it falls on its face for a few seconds and then takes off great. If you throttle the throttle a couple a times it doesn't seem to bog as much and...
Took it to Adventure Marine since I was at a loss and tired of working on it in the heat & sun. The aftermarket intermediate shift cable had too much play so they replaced it with a Sierra cable. Works great.
Well I pulled the lower down just low enough for the shoe to come out of the saddle, didn't feel any excessive play in the linkage and read straight forward. Had to go to work so I will look closer at the linkage in the upper unit. The lower stern drive shaft has all three forward neutral and...
That is how I did it. Used a bungee cord to hold it ccw so unless the shifter moved when I used the prop to turn it ccw to line up the spines, it should have been lined up. Guess I will try it one more time, it was getting hot out there in the sun and I was getting irritated to say the least.
When I started this feeasko I pulled everything off upper and lower. But when I put gear lube it leaked out of the weep holes. It is easier with the upper on the boat for me. Being a SEI unit, just wondering if some how something could have possibly got bent or broken. I didn’t replace the...
It started with replacing the boots and the water pump. Had forward, neutral and reverse, but when I put gear lube in the stern drive it was leaking out the wheep hole. So I pulled the lower drive off and replaced all of the water pump parts again since it was my first time doing this and with...
I have a 1991 Rinker Captiva Cuddy 206 with a 5.7 Mag. Had forward and reverse before I pulled the lower unit off to install a water pump complete with upper pocket. I have tried the bungee cord on the prop, turning the shift rod clockwise until it locks in the prop ccw. Put grease on the upper...
Checked the tank and the fuel, tank is clean and the fuel is fresh I put some fuel in a glass jar and no water. It is a marine carb that I got and with the water separator bypassed it ran great. So I don't think it's the pick up tube but will check it out before this spring. Thanks for helping...
I bought a 1991 Rinker Captivia 206 Cuddy with a 5.7 Mag with a SEI 106 sterndrive. OD398408 engine serial # transom # OD466790. When I got it it would bog and not get going fast enough to get to trim out, after several minutes it would wake up and run the way it should. But then would go to...
