Search results

  1. M

    Prop bearing cage

    And hex nut up top and nut inside casing behind propeller to separate lower unit ? Like to see above the gears ?
  2. M

    Prop bearing cage

    And is there any special alignment when re installing the gears
  3. M

    Prop bearing cage

    Last question in order to get the guts out of the gear case (all the gears ) so I remove the bolt inside the cone behind prop and the nut on top near water pump ? And everything slides out ?
  4. M

    Prop bearing cage

    Also the hex nut on top next to the control shaft is I remove the nut and pry old o ring out would it hurt anything as long as I put a new o ring in because mines leaking
  5. M

    Prop bearing cage

    Everyone talks about how a pain it is to remove that pivot pin and a pain to get it back together makes me nervous as hell lol
  6. M

    Prop bearing cage

    Ok how about the screw on back of housing in between the gear oil fill and drain hole screw
  7. M

    Prop bearing cage

    How about the forbidden screw on the back on the gear housing ? I have a leaking seal I was told never to pull it , also how do I remove the gears inside gear case ? Is it got to do with the nut behind bearing cage ?
  8. M

    Prop bearing cage

    Sorry 1990 force 50 hp
  9. M

    Prop bearing cage

    I bought a lower unit seal kit and there’s a few I’m unsure of how to install , my seal to the hex nut and thread by control rod is leaking and needs replaced , the forbidden screw on lower needs replaced, where does the orange and yellow and very small black o ring go to ? And the larger o ring...
  10. M

    Prop bearing cage

  11. M

    Prop bearing cage

    Where can I find this part ? Mines toast I do believe, I think it’s the prop bearing cage, also how do I install the new seal I got, the forbidden screw on lower unit that connects to control rod
  12. M

    Possible metal piece in gear housing

    Hey I was trying to pry control shaft seal out and my lunch tip broke off and I’m unsure if it fell in, I have spun gears and don’t feel any binding , any tips ? Was told never to remove screw on back and I think I have to to gut gears
  13. M

    1990 spectrum blue fin 50hp force control cables

    Do you think these blue ones will work? There 12 footers and I measured my red ones and they are 12 foot end to end
  14. M

    1990 spectrum blue fin 50hp force control cables

  15. M

    1990 spectrum blue fin 50hp force control cables

    I need a recommendation on where to find two control cables that match these or would work, and how hard is tuning and hooking these suckers up , thanks in advance
  16. M

    Thermostat and pissing issue

    Shoot , guess I need to google around and search for some
  17. M

    Thermostat and pissing issue

    I’m going to check them out hopefully they come with the orings because I seen a few that didn’t come with orings and gasket
  18. M

    Thermostat and pissing issue

    Could a bad thermostat cause the engine not to **** out of the exhaust ? And where is everyone sourcing the replacement gasket and thermostat at 1990 force 50hp
  19. M

    Control rod seal and copper ring for drive shaft and boot

    So just pry the beauty out and pop the new one in? Chances of me over seating it and it falling deeper into the lower unit ?
  20. M

    Control rod seal and copper ring for drive shaft and boot

    Is this not metal fellas ? I tapped it and makes a distinct metal noice
Top