Search results

  1. M

    Two stroke oil leaking into fuel hose, 30hp 1993

    This looks the right parts for the serial number: https://www.marineengine.com/parts/mariner-outboard-parts/30a/689250101-and-up-e/oil-pump
  2. M

    Two stroke oil leaking into fuel hose, 30hp 1993

    I was thinking about disconnecting the fuel line when the outboard won't be used for, let say a week or more, (two-three days tilted it starts fine, smokey though first 10 seconds), then I guess the check valve will be in use, with hose disconnected to the outboard, and neither oil or fuel can...
  3. M

    Two stroke oil leaking into fuel hose, 30hp 1993

    Disconnecting oil injection is not an option as long as it works. It will be hopeless to teach the 10+ different users of the boat to start adding two stroke oil to the fuel tank, the risk of it running without oil is too big. Engine starts fine after a couple of days tilted, but I can't...
  4. M

    Two stroke oil leaking into fuel hose, 30hp 1993

    1993 30hp two stroke Mariner serial no. 689 S 251061 Engine was tilted for two weeks. Upon start up, in ran for 3 seconds and then would not run. It would only run on starting spray fluid after that. I pushed the ball valves in the engine tank and motor connection to the fuel hose to check...
  5. M

    1992 Mariner 30 hp shift linkage nut hits gear housing

    I don't think there is any other way to put this back together, when I just disconnected the swivel nut on the upper rod from the lower housing rod.
  6. M

    1992 Mariner 30 hp shift linkage nut hits gear housing

    Maybe I should disconnect the shift linkage again and check the two rods are back to back, no gap, and the turn the swivel nut to connect them.
  7. M

    1992 Mariner 30 hp shift linkage nut hits gear housing

    Linkage seem to be connected correctly in the way it sits in neutral well, and goes into forward and reverse ok. I only disconnected it from the gear housing to change the impeller. https://www.marineengine.com/parts/mariner-outboard-parts/30a/689550101-and-up-el/gear-shift-linkage
  8. M

    1992 Mariner 30 hp shift linkage nut hits gear housing

    I changed my impeller and put the lower housing together and joined the shift linkage, but now sometimes the locking nut for the swivel nut hits the edge of the gear housing when putting it reveres, making it tricky to get shift to reverse sometimes. I am thinking about filing the edge of the...
  9. M

    1993 Mariner 30hp, ignition key off won't stop engine

    Thanks. I'll check between Black and Black/Yellow.
  10. M

    1993 Mariner 30hp, ignition key off won't stop engine

    I have a 1993 Mariner 30hp with a Quicksilver remote controller. Outboard has electronic starter. When I turn the ignition key off, the engine still runs. What usually is the problem and where to start looking for ground issues? I tried to replace the ignition switch assembly, but did not fix...
Top