Search results

  1. C

    vista 268 Kohler 5e Generator

    Well still stuck and wanted to know if someone has some ideas. Per the picture below the CHTR (choke heater has 54 OHMS of when I connect both N (neutral) and 70 (this should be 12 Volts) I get 18 ohms also on the circuit board P1 red circle I get 18 Ohms. Should I see an open circuit between...
  2. C

    vista 268 Kohler 5e Generator

    O.k. a little progress...K4 led is not LIT and upon further investigation both positive and negative for the 12-volt power for the fuel pump is shorted to ground. The problem is there is no way I can get the wiring harness unless i take the generator off. Thanks Alonso
  3. C

    vista 268 Kohler 5e Generator

    Actually electronics i can trouble shoot is just a pain cause there's very little space to work ;) Alonso
  4. C

    vista 268 Kohler 5e Generator

    Well, I can confirm no volts are going to the fuel pump. The fuel pump is new so probably an issue with one of the relays.
  5. C

    vista 268 Kohler 5e Generator

    Thank you... at the risk of sounding dumb... this is basically putting a gas tank higher than the generator? THanks Alonso
  6. C

    vista 268 Kohler 5e Generator

    So the selenoid was bad however I do not get any fuel into the carb. I was able to spray starting fluid into carb the generator starts and dies. Can I check just the voltage to the fuel pump or do I need to check the control board? Thanks Alonso
  7. C

    vista 268 Kohler 5e Generator

    Unfortunately, my generator does not have a screen... I took the selenoid out and bench tested and it never closes.... so it looks like is bad. Getting a new one in the next couple of days... will let you know how it goes. Thanks Alonso
  8. C

    vista 268 Kohler 5e Generator

    Thank you for the reply and clarification regarding the double pole breaker. I was able to jump the starter and it turned over... This should tell me that the started is good but the selenoid is bad correct? Thanks Alonso
  9. C

    vista 268 Kohler 5e Generator

    Good Morning Trying to figure out my generator and how it operates. When I try to start it both remotely and locally I just get a clicking noise. Also in the cabin, I have both a switch to start the generator and another (white switch) to enable see image below.... not sure what the starting...
  10. C

    Vista 268 Water Heater

    The water pump was replaced... I get plenty of pressure when I turn the cold water on. However, when turning the HOT water nothing comes out. Turning the cold water I get cold water and after a minute the water starts to heat up. Just not sure why when I turn the hot water nothing comes out...
  11. C

    Vista 268 Water Heater

    Hello I'm getting the following problem with my water heater—no pressure out of the hot side. I get plenty of pressure once I turn the cold water on. Also when I turn the cold water on I get a mixture of hot and cold water after the heater has been on for a while. I disconnected the red...
  12. C

    vista 268 Bildge pump

    Alldoge/4now04 Thanks, guys I followed both of your instructions, and now the Bildge pump and float work. Alonso
  13. C

    vista 268 Bildge pump

    Good Morning a bit confused about wiring my bilge pump with the float switch see the image below. I need to know what I connect the float wires to. Also, I checked the float, and both cables are shorted meaning I can show continuity between them. Is that correct? Thanks Alonso Switch...
  14. C

    268 vista spotlight

    Haha I waisted a few hours on this project lol
  15. C

    268 vista spotlight

    Hello Guys at the risk of sounding stupid my spotlight only moves left and right. I have been troubleshooting to make sure it also goes up and down, however when I pulled the motor for the light this is what I found. The motor only has one gear left and right ... am I missing something...
  16. C

    2001 Vista 268 Battery Switch

    Do you happen to know if the starter wire goes directly to Feeder (Battery Switch) or goes directly to the starting battery? Thanks
  17. C

    2001 Vista 268 Battery Switch

    Have one final question regarding the connection of the battery switch Bat 1 on the schematics attached goes to engine starting battery, Bat two goes to house battery.... Where does the starter wire go to? Feeder?
  18. C

    Volvo Penta 5.7 GSI

    Alldodge Thanks for all your help. Alonso
  19. C

    Volvo Penta 5.7 GSI

    Alldodge O.k. I do have a battery charger so this diagram helps.... Just have one question out of curiosity... Why use the orange wire coming out of the alternator and not the red one to connect to the battery isolator? Check the battery isolator and it is not open or shorted. Thanks Alonso
  20. C

    Volvo Penta 5.7 GSI

    Hello Guys after tracing some wires I found out that the battery isolator is cut and it would appear that at one time it was connected o the starter or starter coil. The other two wires from the battery isolator are not connected to a battery switch but I have not traced where exactly they...
Top