Search results

  1. G

    Buddy is having problems with his older envirude engine revving up on its own

    Buddy has a '93 40 horse Evinrude and is having problems with the motor revving up to 5-6000 rpms on it's own and he can't figure it out. He said when it revs up the throttle plates are not opening up and if he turns the electric choke on it idles back down. Also he said when it revs up the the...
  2. G

    Need help figuring out which rebuild kit for trim/tilt

    I have a 2003 F80TLRB that the trim seeps a little oil from under the threaded cap the lift shaft goes through. I'm thinking the big o ring under that cap is bad. I looked on a couple sites online and can't figure out which kit I need or if I should just get the one o ring. Also looking for an...
  3. G

    Found a small o ring on the ground I don't know where it came from

    I just got done with a transom install and found a small o ring on the ground under the motor and I have no idea is it's mine or was already on the shop floor. I don't remember there being any o rings in any of the linkages. i did drop the lower unit to replace the hose that runs the...
  4. G

    Transom question

    In the process of tearing the transom apart and have two questions about the cap. First- I was planning on putting a heavy layer of 4200 under the cap when I reinstall so it squishes around and seals it up but there is a strip of foam glued to it that is wet. So I remove the foam and go with...
  5. G

    3M 4200 ok

    Getting supplies coming to redo the transom on my boat and ordered 4200 instead of 5200. Will the 4200 work ok to seal the motor and through bolts on the transom? This is on an aluminum boat
  6. G

    transom replacment on a 2003 Crestliner FishHawk

    I have an '03 FishHawk 1650 with a bad transom. I'd like to do it myself to save money but I'm a little unsure whether I should or not. How bad of a job is it really, some guys say it's a solid 40hr job then the next says it's not that bad. Next question. Where should I go to get the parts I...
Top