Found a small o ring on the ground I don't know where it came from

gunner76

Cadet
Thread starter
Joined
May 9, 2020
Messages
18
I just got done with a transom install and found a small o ring on the ground under the motor and I have no idea is it's mine or was already on the shop floor. I don't remember there being any o rings in any of the linkages.
i did drop the lower unit to replace the hose that runs the speedometer and to check the condition of the impeller but I didn't see anything fall out at the time.

ETA. The motor is a 2003 Yamaha f80b 4 stroke
 

gunner76

Cadet
Thread starter
Joined
May 9, 2020
Messages
18
Forgot to mention the o ring is about the diameter of a pencil and the inner hole is half that width.
 

gunner76

Cadet
Thread starter
Joined
May 9, 2020
Messages
18
Figured it where it goes. Started watching you tube videos and found a parts diagram on the internet and the o ring goes on the little splined shaft in front of the water pump housing.
 

Grub54891

Admiral
Joined
Jun 17, 2012
Messages
6,492
the o ring goes on the little splined shaft in front of the water pump housing. ​
That would be the shift shaft.
 
Top