Search results

  1. F

    1993 Evinrude 200 2 stroke saltwater series

    Good afternoon all, Recently purchased a boat with twin Evinrude 200 Saltwater series 2 stroke motors. Both motors “pee” however the port engine seems to not have as much pressure and is quite a bit hotter than the starboard engine. I was going to replace the thermostats in both engines and head...
  2. F

    1983 35HP bogging down

    Good afternoon everyone, I have a 1983 35HP Evinrude that boggs down and stalls after half throttle. It will not run without 3/4 manual choke. Otherwise it will run but stall when I put into gear. Primer bulb not staying firm. I’ve rebuilt the carburetor about 2 months ago, but have not run it...
  3. F

    1983 Evinrude 35HP

    Good afternoon all. I have a 1983 Evinrude 35HP that’s overheating. It was sitting covered for 5-6 years. So far I’ve replaced the impeller, and thermostat. I’ve also unplugged the water discharge tube from the intake to make sure it wasn’t clogged. Overheat buzzer is coming on after about 1-2...
  4. F

    1983 35HP Evinrude thermostat

    Good evening, I’ve recently purchased a 35HP Evinrude outboard that’s been sitting for 8 years. Rebuilt the carburetor, runs great, noticed it wasn’t peeing though. Replaced the impeller, which it desperately needed, still not peeing. I’m going to replace the thermostat next. I can’t seem to...
  5. F

    1989 Mercury no spark

    No spark on 3rd cylinder coil is good any ideas? Thanks
  6. F

    1989 Mercury 90hp direct oil injection

    I'm going to bypass the direct oil injection system, it's injecting too much oil, I will now be premixing into the gas tank. Question though, will the existing inline fuel filter work? I was thinking, since the oil will be going thru the filter, it might limit the flow. Thoughts? Thanks
  7. F

    1996 112 SLP

    Where can I purchase the bushing that attaches to the linkage that operates the butterflies, and the retainer clip as well. I cannot seem to find one online
  8. F

    1989 90hp Mercury no spark

    Just rebuilt all three carbs and now I have no spark. 2 carbs were leaking fuel and I was having acceleration issues, but once it was going at WOT it ran fine, only when trying to plane it struggled to RPM. Now after pulling the carbs there's no spark any ideas
Top