Search results

  1. C

    1976 collins craft.I have the boat off trailer and upside down.It has been washed with muritic acid.I am going to sand with 80 grit and use 2 part

  2. C

    1976 456hh 45 hp.magneto model

    The top plug quit firing after about 1 hour run time.I replaced both plugs with new ones and it happened again.I installed one of the used ones that I had cleaned,while on the water ,top cylinder again.The plug looked good both times what would cause this.Motor has set up for years .My dad...
  3. C

    Yamaha foot rebuild

    my friend hit a stump ,broke a tooth on the forward gear.2006 75 four stroke.I rebuilt the foot.In the vise it shifts into all gears.When we try to install it on the powerhead it will not bolt up unless the shifter is in reverse.At this point the gearcase is in neutral ,the throttle at the helm...
  4. C

    Evinrude cowl seals

    I need one for a 1976 evinrude 40 hp.These are no longer available.I have several vintage motors that need these.Are there any aftermarket seals that will work
  5. C

    70's coil

    Will the green coils off a 70's 85 hp work on a 1976 40 hp.I know the connectors will have to be cut off and spliced.How can you check the cylinoid
  6. C

    70's coil and cylinoid

    Will the green coils off a 70's 85 hp work on a 1976 40 hp.I know the connectors will have to be cut off and spliced.How can you check the cylinoid
  7. C

    Evinrude te60tlene 92 60hp miss

    buddy of mine is having problems with this motor.cleaned carbs new fuel tried 2 different tanks took coils off running motor no different compression 98 96 92 new plugs could this need a head gasket this compression seems low with my guage
  8. C

    1984 evinrude 15 up e15ecrm

    When button is pressed nothing happens.Itookstarter off and hooked it to jumper cables it works.I took push button apart and cleaned contacts still nothing.Help
  9. C

    suzuki dt 30c 1989 model 2 stroke

    When I got this motor the carbs were missing.It has a new thermostat and water pump .It is loosing rpms and the red light comes on.I do not think the oil injection is working so I am mixing it in the gas.How can I disable the oil injection to stop it from loosing rpms.Also the warning buzzers...
  10. C

    suzuki dt 30c 1989 model 2 stroke

    The red light comes on and I am loosing rpms.It has a new thermostate and is pumping water.Ido not know if the oil injection is working . I am adding oil to the gas. How can I disable oil sensor so I can check and see if this is the problem.Igot this motor with no carbs on it and the warning...
Top