Search results

  1. P

    2014 90 hp Mercury outboard - overheating, Impeller???

    Good day everyone, I have a 2014 90hp merc, with maybe 25 hours on it. My issues is that I was travelling through some eel grass, and the engine sort of cut out over revved and started beeping (3 beeps), the engine was not spitting water out. I stopped the engine and pulled some eel grass...
  2. P

    Boat pulling port hard when on plane and WOT

    Hello everyone! I have a new Crestliner Kodiak 16ft aluminum Deep V with a Merc 40 Tiller. All new gear. Boat is around 800 pounds with gear... My issues is that when I am up on plane and running wide open throttle the boat start to pull aggressively port... So much so that I have to come off...
  3. P

    2013 crestliner kodiak 16, with 40 hp merc

    Hey gents, I'm about to pull the trigger on a crestliner 2013 16 ft kodiak tiller, with a 2014 merc 4 stroke 40 hp. I'm curious what some peeps think May think my approx WOT top speed will be. The boat had an .80 guage hull and weighs 700 pounds, 75 inch beam and is 16 ft 6 inches long. The...
  4. P

    1988 Johnson 4hp - full throttle cut out

    Re: 1988 Johnson 4hp - full throttle cut out Here's another for where I'm thinking the bottom of the float should be aligned?
  5. P

    HIgh Speed nozzle crack

    Re: HIgh Speed nozzle crack Thanks for the replies guys, I'm going to fill it lightly with J B Weld 2 part epoxy this afternoon, here's a pic.
  6. P

    1988 Johnson 4hp - full throttle cut out

    Re: 1988 Johnson 4hp - full throttle cut out Heres a couple pics of my Float, to me it seems as though it needs to be set a little lower?
  7. P

    HIgh Speed nozzle crack

    I have a 1988 4 hp 2 stroke, It will not run full throttle for very long before bogging out. The only thing I can find wrong with my carb is that there is a small hairline crack in the top of my high speed nozzle/jet. It does not run the length of the nozzle however is at the top and down...
  8. P

    1988 Johnson 4hp - full throttle cut out

    Re: 1988 Johnson 4hp - full throttle cut out Thanks a lot for the reply Daviet, I cleaned the carb as well as I could. I basically took everything apart that I could. By the high speed nozzle do you mean the nozzle in the pic? I'm no mechanic I just plug away at this stuff myself. Also...
  9. P

    1988 Johnson 4hp - full throttle cut out

    Hey everyone, I have a 1988 Johnson 4 hp outboard (2 stroke). My issue is that on full throttle she will run for about a minute or 2 and then it boggs down and cuts out. If I cut back on the throttle chances are it will keep running. If it does not than I pull the cord and off she goes again...
Top