Search results

  1. T

    1984 Johnson J70TLCRD 70hp

    Hard start after initial start but if given a half second squirt of starting fluid, it fires right up. It runs fine after starting. Suspect carb problem? Bulb is new and hard but sometimes has to be pumped soon after running. Should I have a check valve in the line? Boat is 80's vintage Blue...
  2. T

    1984 Johnson J70TLCRD T/T gauge hookup

    I need help finding the signal hookup connection or wire to the T/T gauge. I have (2) black wires coming for the switch at the T/T unit, to the box in front of the flywheel. Do I have a wire in the harness, to the front for the hookup or do I have to run one up to the gauge from the motor and...
  3. T

    65esl72 Johnson outbard, surging at high speed

    I replaced the fuel pump as, at that time it ran much better when pumping the primer bulb. I removed and cleaned the carbs and noticed the floats were on an angle when inverted. Manual calls for 1/16" clearance and "parallell". I checked and replaced a couple of fuel lines from pump to carbs; no...
  4. T

    Neptune AL 135

    I need the ball screw assembly. Does anyone know where I can get Neptune parts? I can't find an address or phone number online.- Thanks, Jerry
  5. T

    1972 hydro electric 65 HP Johnson 65ESL-72S shifting problem

    1972 hydro electric 65 HP Johnson 65ESL-72S I bought a project boat and the lower unit was missing from the above motor. I bought a second motor of the same model # and swapped the lower unit (low compression on the second motor). When swapping I installed a new impeller and Evinrude/Johnson...
  6. T

    Chilton gas tank cap

    I saw a post asking about a new cap for a Chilton tank and yesterday I found one for mine at West Marine. It does not have the fuel gauge but I can look in the tank. :) Part number 13099544...............$12
Top