Search results

  1. mtboatin

    Trim/ tilt Volvo dp1?

    I purchased a 1994 Cobalt 272 with a 454 DP- 1 Volvo Penta. It looks like the PO swapped out the controls to a MerCruiser unit. It has a trim switch on the throttle handle but there is also a rocker switch rear ward of the assembly that is separate. Assuming that the switch on the handle is for...
  2. mtboatin

    Bearcat 55 impeller and oil filter help

    I have twin Fisher Pierce Bearcat 55s that came on a recent boat purchase and need to get them mechanically sound. Weather I keep them or not. I've beaten the internet and talked directly to Globe on the impeller (part # 223) and they seem to no longer be in existence. Looks like the same...
  3. mtboatin

    Vintage Tire Issues

    So first endeavor on bring back my new to me 1958 Crestliner Vagabond and Gator tandem trailer has been to source tires for my tandem Gator trailer. A word of WARNING to those thinking about buying a vintage boat trailer! Who would have thought it would be so difficult? I would also welcome any...
  4. mtboatin

    1958 Crestliner Vagabond

    Hello all. I just picked up a 1958 Vagabond that needs restored. Looking for any and all info I can find. I've gotten a few things off fiberclassics.com. It looks to have only been built in 1957 (for $3236.00) and 1958 (call dealer for price). She's 22' with twin Fisher Pierce Bear Cat 55s...
  5. mtboatin

    1956 Aluma Craft Deep "C" seat back option

    I have a Deep "C" that I'm bringing back that has the seat back option on two of the three seats. I would like to find a third set of the aluminum brackets and even the tube frame to add this to my third (rear seat) if anyone knows where to find a set. The frame is not as big a deal as I could...
  6. mtboatin

    Aqua Power 95001 Heavy Duty Docking Light upgrades?

    I have a '94 Cobalt 272 with a set of Aqua Power 95001 Heavy Duty Docking Lights which I'm sure were cutting edge in '94...
  7. mtboatin

    Duo prop seal replacement

    Hi all. I have a dp-d1 I believe which is new to me this past summer. Finding lower unit oil looking a little milky even after changing it and only running it about five afternoons. I finally got around to pressure testing and at 3lbs. held fine at 10 min. I took the pressure up to 10lbs...
  8. mtboatin

    7.4 gl PMDM no spark.

    I have this posted in a another post concerning top speed and RPMs but since this is unrelated I thought I'd start a new one. I ran out of fuel for the purpose of getting four year old fuel out. Had to be towed in by a buddy . Each time I cycled the key and pump the throttle to Prime the carb...
  9. mtboatin

    Old Lowrance 3200 depth finder help

    I have a 1994 Cobalt 272 with an old Lowrance 3200 depth finder that seems to be on the blink. I called Lowrance and Cobalt with not much help. Looks like I will replace the whole unit with a Hawkeye DT2B. I'll have to make some type of trim to take up the odd size hole in the dash. I may...
  10. mtboatin

    Early Cobalt Seat Help Needed

    My 1994 Cobalt 272 pedestal seats have no plastic bushing between the column and seat base. Pretty medieval working set up. Trying to determine if they originally had a bushing of some type in there and if so what type. Also the main seat base that has the upholstery and cushions stapled to...
  11. mtboatin

    Servicing DP-D1 lower unit

    Serviced my lower unit with Amsoil. Online info said it takes about 2.7 qts. Drained unit, removed dipstick and back fill plug and filled from the bottom. My question is do you fill till it comes out the back plug to gauge level. This was my understanding. But it took a little over 3 qts...
  12. mtboatin

    7.4GL temp sender info needed

    Hello all. I recently purchased a 1994 Cobalt 272. This boat is equiped with a 7.4 GL PMDM, DP-D1 drive, and B2 props. Temp gauge reads 120 at most. Found original sender bad. This is the one that screws straight down into the water pump at top center. Can not find a part number any where...
  13. mtboatin

    Top Speed Issues

    Hello all. I recently purchased a 1994 Cobalt 272. This boat is equipped with a 7.4 GL PMDM and B2 props. Slowly going through things. Boat has sat close to three plus years with a full 98 gallon tank. Fuel smells fine but you know....three year old fuel. Added multiple high end fuel...
  14. mtboatin

    Volvo Penta info needed.

    Hello all. I recently purchased a 1994 Cobalt 272. This boat is equiped with a 7.4 GL PMDM, DP-D1 drive, and B2 props. Slowly going through things. In the processes of removing the props I found that I am missing washers. Having a hard time finding current resources/diagrams showing the...
  15. mtboatin

    Best Vintage '40s-'50s big outboard

    I have a 1956 Alumicraft Deep C I'm playing with. Old literature claims it can handle up to a 60 hp short shaft. Right now I have a 1974 50hp Evinrude that works fine but just doesn't look the part. I would love any info on what would be the oldest Johnson or Evinrude 50-60 hp (preferably the...
  16. mtboatin

    Vintage Alumacraft or Crestliner?

    I now own a 1956 15' Alumacraft Deep C which I've been fixing up over the last year and is pretty well complete. I just ran across a 1959 17' Flying Crestliner for sale in about the same condition according to the pics and phone discussion but it is several hours drive from my home. My...
  17. mtboatin

    Trolling Motor on Vintage Boat?

    I have a '56 Deep C that currently has a '74 50hp Evinrude with cable & pully steering on her. I recently picked up a '46 5.4hp Zephyr thinking it would make a sweet little trolling motor. Has anyone installed a troller of this size next to there main power plant and made it work smoothly...
  18. mtboatin

    Vintage Outboard Opinions Needed

    I'm playing with my new '56 Alumacraft Deep C which now has a '74 Evenrude 50 hp on it. Even at idle we"re moving a little fast for trolling. I'd like to eventually find a 40's-50's 50-60 hp OB. Vintage boating is a new hobby to me and I have a lot to learn. I just ran across a local 1948...
  19. mtboatin

    Three older engines--which is most desireable?

    Found these on CS and have been kicking around a vintage short shaft for trolling on my 15' Deep C. I have a '74 50 Evenrude and even at idle were moving a little faster than I'd like. Any info or opinions would be great. http://kalispell.craigslist.org/boo/
  20. mtboatin

    Old Remote Spotlight Repair Help

    I'm trying to rebuild an old remote control spot light. The light position was controlled by a mechanical knob and cable. I found the cable was seized in it's copper tube housing. I'm having trouble finding 1/4" cable 40" long. Would be great to find in SS. It has a straight wire core with...
Top