Search results

  1. C

    Force 5 Hp stuck in forward gear removing drive shaft

    The shift lever on a used outboard I just purchased wouldn't move. In diagnosing the problem, I first seperated the foot from the motor and was able to shift between neutral and forward using the shift road. While in forward I could also spin the prop which would turn the drive shaft. That...
  2. C

    Removing casting platform

    I have a 91 smokercraft. I'm redoing the floor and carpet and would like to remove the casting platform and extend the floor to the bow. I'll have to grind down the rivets holding the platform brackets to remove them. I'll need to then replace the rivets. How do I find the correct...
  3. C

    30hp mariner Engine surging

    Hi, I'm looking for some advise for a surging issue. I recently rebuilt the carb and replaced the fuel pump, gas tank ( with fresh fuel) and fuel line to my 1985 Mariner 30 hp. The engine idles well and runs fine until about 3/4 throttle then it starts to surge. Tank is the new EPA...
  4. C

    Replacement fuel pump for 1985 Mariner 30 hp

    I have a 30 Ho mariner by Yamaha, s/n 109546 Would anyone know if I can replace the fuel pump with the YAMAHA OUTBOARD FUEL PUMP ASSEMBLY #6A0-24410-05 / -03 / -04 OR #692-24410-00-00 Or the Mallory 9-35300 Thanks Steve
  5. C

    Fuel draining from carb back to fuel pump

    I purchased a 1972 Evinrude Yachtwin 4hp. I had to replace the fuel line to the carb and used a clear tubing rated for fuel. Only thing of correct diameter available at the time. Having trouble getting the motor to run. Note it ran when I purchased it a few days ago at the sellers house...
  6. C

    1985 mercury mariner flywheel torque spec

    Hi, I am putting the flywheel back on my outboard after replacing the lighting coil. Does anyone know the torque spec? 1985 mercury mariner 2 stroke Serial # 689 S 109546 Model 30E0 Thank you for your help
Top